I need to know the location

the knock sensors are threaded in to the block on either side of the engine. One is located near where the oil dipstick tube goes into the oil pan. The starter will need to be removed to see/replace. The other is in he same place on the opposite side of the engine.

I’m happy to assist further over the phone at https://www.6ya.com/expert/jeremy_d728a59f986299fa

Here's a link to your knock sensor Luis. SAVE 20 GET 10 GIFT CARD ON ONLINE SHIP TO HOME ORDERS OF 100 OR MORE Here's a new knock sensor. http://www.autozone.com/engine-management/knock-sensor/duralast-knock-sensor/mazda/mazda6/2006/4-cylinders-c-2-3l-mfi-dohc/828292_0_0

The knock sensor is located under the intake manifold to replace do the following
Disconnect the negative battery cable.
Remove the intake manifold.
Disconnect the sensor connector.
Remove the sensor from the engine block.
Installation is the reverse of the removal procedure

the knock sensors are located underneith the intake manifold on either side of the engine block. you have 2 of them

the knock sensors are located on the cylinder heads. the connect to the wiring harness almost directly in the middle of the intake manifolds on the center of the top of the engine. There are two, one for each bank, with each having two sensors per bank. Bank 1 is cylinders 1-6 which is located on the driver's side I beleive.

If you have a 2.3 then the knock sensor location is under the intake,center of the engine block. If you have a 3.0 the knock sensor location is at the rear corner of rigth cylinder block.

Fig. Component Location Chart-2000 MPV

1 PCM 2 Mass air flow (MAF)/intake air temperature (IAT) sensor 3 Throttle position (TP) sensor 4 Fuel tank pressure sensor 5 Engine coolant temperature (ECT) sensor 6 Crankshaft position (CKP) sensor 7 Camshaft position (CMP) sensor 8 Knock sensor 9 Heated oxygen sensor (HO2S) (front, LH) 10 Heated oxygen sensor (HO2S) (front, RH) 11 Heated oxygen sensor (HO2S) (rear, LH) 12 Heated oxygen sensor (HO2S) (rear, RH) 13 EGR boost sensor 14 Power steering pressure (PSP) switch 15 Main relay


Fig. Component Location Chart-2001 MPV

1 PCM 2 Mass air flow (MAF)/Intake air temperature (IAT) sensor 3 Throttle position (TP) sensor 4 Engine coolant temperature (ECT) sensor 5 Crankshaft position (CKP) sensor 6 Camshaft position (CMP) sensor 7 Knock sensor 8 Heated oxygen sensor (HO2S) (front, LH) 9 Heated oxygen sensor (HO2S) (front, RH) 10 Heated oxygen sensor (HO2S) (rear, LH)* 11 Heated oxygen sensor (HO2S) (rear, RH)* 12 EGR boost sensor


Fig. Component Location Chart- 2002-06 MPV

As far as there being no knock sensor on a 99 2.2 I beg to differ. I have a 99 legacy and just had a diagnostic done and mine is bad. If there is no knock sensor why would it say it was bad and why does Auto Zone, Advanced Auto and my local Subaru dealer sell them. Mine is located under the throttel body and they are rather hard to get to. No offence to who ever said ther is no knock sensor but maby you should recheck your information becuse I know there is a knock sensor since I just changed mine.

i have toyota windom 4vz-fe i need locate knock sensor

it picks up nois inside of the motor it is located in the side of the block under the intake sometimes right above the starter