P1507 code - Explorer Ford Cars & Trucks

The P1507 code means that the engine idle is out of factory specification. Sometimes the Idle Air Control (IAC) may have carbon built up.

2002 Hyundai Elantra DTC P1505 AND P1507 Engine Performance same as kia

Possible causes
- Faulty Idle Air Control (IAC) valve
- Idle Air Control (IAC) valve harness is open or shorted
- Idle Air Control (IAC) valve circuit poor electrical connection
What does this mean? Tech notes
The P1507 code means that the engine idle is out of factory specification. Sometimes the Idle Air Control (IAC) may have carbon built up. Disconnect the car battery, remove the valve, clean, re-install valve, and drive the vehicle for about 5 minutes with the headlights and A/C ON to get the idle relearned.
If the problem persist, the IAC valve may need to be replaced.

Read more: http://www.engine-codes.com/p1507_ford.html#ixzz3sFPyZe00

Possible causes for P1505 & p1507
Faulty Idle Speed Control Actuator valve, harness is open or shorted, Idle Speed Control Actuator valve circuit poor electrical connection. No the codes are not related to the EGR. P0198 is related to the engine oil temperature sensor. By the way you should use a meter as supposed to a test light. The test light will not be able to measure 5 volts reference or voltage drops. However I would try replacing the affected parts based on the codes and the info you've provided. Good luck.

P0175 indicates an overly rich condition on bank 1, and with the air delivery codes posted, this may resolve itself when the issue causing the other two codes is addressed.

P1504 and P1507 indicates problems with the Idle Air Controller valve. The Ford manual suggests to check the resistance across the two terminals on it. The IAC valve is under the plastic engine cover. I circled it in red on an image here for you.

P1451--Evap Control System Canister Vent Solenoid
Circuit Malfunction
P1507-Idle Air Control Underspeed Error

Codes you get DO NOT tell you what to replace

They give you a place to start testing

You cannot do that

Testing requires special euipment
and knowledge

You need a repair shop

Repair information for the OBD-II trouble code P0420 - Catalyst System Efficiency Below Threshold (Bank 1)

Answer P1507 means "Idle Air Control Underspeed Error". It can be most commonly caused by a vacuum leak, a damaged Idle Air Control (IAC) assembly or a stuck IAC valve that ...

p500=Vehicle Speed Sensor Malfunction (VSS)
p1540=VSS Signal Too High
P1507= Vehicle speed/Idle Speed Actuator
Speed sensor is faulty or has a bad connection.

P1507 is "Idle Air Control System Underspeed Error". This code indicates a problem with the Idle Air Control (IAC) valve assembly, harness wiring for the IAC or the Powertrain Control Module. So checking the IAC next is the most logical step.

p0171 indicates the system is running lean on bank 1,p0174 means the system is running to lean on bank 2 p1507 is an idle speed under run fault i'd suspect an air leak is the cause of your problem check air intake system for airleaks