How do i replace the rear tun signal on a 2005 gmc canyon

Look for corrosion in the plug. They get corroded and you can clean them or replace them.

There isn't one. There's two fuses for the turn signals. The flashing is controlled by the Body Control Module.

http://www.stockwiseauto.com/product_info.php/products_id/324058/fit_id/11132/Year/2004/Make/GMC/Model/Canyon?gclid=CJGg7sPHhsMCFRRcfgod5gsA9g
you can find it at almost any auto parts store just to give u an idea. Right side kicker panel. Good luck.

If the other windows work, probably the motor.

All fuses and circuit breakers for a 2005 GMC Canyon are located in the engine compartment fuse block.

This subject is covered in the 2005 GMC Canyon Owner's Manual on pages 5-98 through 5-102.

If you do not have an Owner's Manual, you can download a free PDF version clicking on the following direct link:

2005 GMC Canyon Owner's Manual

2005 gmc canyon.driver side window and lock does not work.have relpaced switch. the new switch now giving the same problem.

check the rear bulb? or it maybe a bad socket in the front

it means that your fuel is running too rich,and needs more oxygen for a cleaner burn. i think that your oxygen sesor may be faulty,but have autozone run the trouble codes for you,and see what exact part is bad.

Stones in tire treads? Pull the rear wheels for a look-see. Inspect brakes and all hardware. Have then lubed. Make sure linings or pads are not glazed to eliminate squeaking noise.Make sure parking brake works properly and smoothly. It may beone or more of those things. Good luck there, pardner.

No, but that's probably where your problem is. The wires get the hell beat out of them by stones, and then they short out and cause problems. I would take a look at it.

have your plug ins changed they have had a lot of trouble out of them