SOURCE: 2007 Chevy equinox door lock latches engaged
Did you unlock doors and pull handles like to open, then try?
SOURCE: hatchback lock on 2005 subaru outback will not engage.
Check the Handle and make sure it has returned to fully closed. They tend to build a little rust and do not return all the way. If that is not it I would check the latch itself to see if it moving properly and not already in the closed position. Sometimes they will stick and when you try to close it will lock before it has caught the pin. If that is the problem you can spray with WD40 and operate handle while pushing out with screw driver. Good luck and have a good day.
SOURCE: door locks and power window
Just did this procedure I got from coloradofans.com forums:
"any type of power/voltage change
seems to trigger this issue
The most common symptom is power
locks fail and only the driver window quits, however that is on the
extended cab.
Steps to fix and it works every time.
take
door panel off driver's door
Disconnect the wiring attached to window
and power lock control unit
disconnect battery cables
connect
the negative to the positive cable(((NO BATTERY CONNECTED)))
This
will act to short residual voltage in the system
5 minutes later
place
the key in the ignition and turn to the run position
connect the
wiring to the window/lock controller
connect the negative cable to
the battery
then the positive
open drivers side door
turn key
to the off position((do not remove yet)) you should get a series of
dings through speakers telling you the key is still in the ignition
once
it begins dinging pull the key out and you should hear the door lock
solenoids trigger and the windows should work." - Coloradofans.com forums
134 views
Usually answered in minutes!
×