Possible bad or damaged ground cable. Check both ends.
SOURCE: Entering a 2003 Hyundai Tiburon with no remote.
I belive all you have to do is put the key in the ignition and turn it counter clockwise. Hopefully that works for you.
SOURCE: Hyundai Elantra brake and battery light on consistenly on car
check to make sure alternator belt not slipping . check fuse link and the alternator electrical wires make sure they are not frayed or broken.
SOURCE: 2000 Hyundai Tiburon will not start
There is NO possible electrical cause (within REASON) which would create the problem you describe. I assume you tried the Keyless Entry Remote to DIS-ARM the anti-theft system. If the ALARM system was activated, it will stay activated until it's de-activated by the remote (typical design feature). The best SOLUTION is to take vehicle into Hyundai an have the problem diagnosed.
SOURCE: Need Instructions on 2003 Hyundai Tiburon Clutch Replacement
Go to http://www.hmaservice.com/ and register (vehicle by VIN). Afterward, you'll have access to technical information (manuals, wiring diagrams, service bulletins, etc) about your vehicle.
SOURCE: 2004 Hyundai Elantra won't start,
The 'Keyless Entry & Burglar Alarm System" is activated. You must 'Disarm' the system using the Keyless Entry Remove (Key Fob) to "Reset" the system. The reason the engine won't start is due to the burglar alarm - it has a "Starter Kill" circuit which is activated when the alarm is activated. The alarm must be DEactivated to DEactivate the 'Starter Kill' circuit.
Another way to start the engine is to get in the car, put the key in the ignition and turn it to 'ON" and wait 3 to 5 minutes until the emergency flashers stop/turn off. Afterward, you should be able to start the engine. NOTE: This does NOT reset the burglar alarm. It will go off again when you enter the vehicle without using the remote/key fob.
327 views
Usually answered in minutes!
×