How to reprogram VW Touareg Key to car?

SOURCE: remote key fob will not work-battery replaced

VW/AUDI/SEAT/SKODA



Remote Control Programming (1997 ON)

Procedure
1. Switch Ignition ON and leave the key in the ignition.

2. Mechanically lock the vehicle using the Drivers door using a second
key.

3. Using the remote control press the Unlock button once, and the horn
will sound once.

4. Wait 6 seconds and press the unlock button once to activate the coding
procedure. The remote control will now be programmed.

NOTE : When performing programming on additional remotes the procedure
is the same, except you press the unlock button 2, 3 or 4 times for the
different remote.

For example : If programming 2 remotes press the unlock button twice with
a 1 second interval between each press, repeat for 3 and 4 remotes.

5. Switch Ignition OFF.

6. Remove key from ignition and check for operation.

7. The coding procedure can be repeated up to 4 times for additional remotes.

8. The ignition must be switched OFF between programming each remote
control.

Remote Control Erasing (1997 ON)

Procedure
1. Switch Ignition ON and leave the key in the ignition.

2. Mechanically lock the vehicle using the Drivers door using a second
key.

3. Press the remote control unlock button 5 times in 1 second intervals.
A short horn will sound.

4. Wait 6 seconds and press the unlock button once to activate memory
erase.

5. Switch ignition OFF, all remotes are now erased.

SOURCE: focus remote key fob not working

this info would cost you £30.+ at ford Radio Frequency Programming Instructions:

• Insert the ignition key and turn from position II (Ignition) to position 0 (All off) and back four times within three seconds.
• Remove the ignition key. The locking control system is now in "learn mode" for the next 20 seconds and the red warning system LED (By the clock) stays on continuously to indicate this.
• During the 20 seconds press one of the transmitter buttons. The remotes signal and code number is learned by the locking module and is indicated by flashing the warning system LED.
• Wait until learn mode times out (20 seconds) or switch the ignition back to ON.nfrared Programming Instructions:
• Put your key into the ignition and turn to position 1 (Radio). After approximately 10 seconds the red alarm control LED (next to the clock) should illuminate. As soon as it comes on remove the key from the ignition - the LED should remain lit.
• Point the remote's "eye" at one of the front door sensors and press the rear button until the light on the transmitter illuminates (Keep the button pressed)
• With the rear button held in press the front button 4 times then release both at the same time. The control lights in both clock and fob will flash 4 times to indicate programming complete.
• Turn the ignition back on to exit programming mode

SOURCE: the battery in my VW key fob is dead, now I cant start the engine

No. VW has made it nearly impossible to solve any key-related problems without a costly visit to the dealership. Battery must be replaced, and I assure you. the dealership will advise you that the ONLY place that you can find that particular battery is from the dealership. They like it that way.

SOURCE: VW Touareg V6 2005 - Battery seems dead, nothing works

under the hood is a positive post and a neg post to jump start ur ride.

SOURCE: How do you replace the battery in the remote control with key?

the switchblade key comes apart buy lightly prying the 2 halves apart with a pocket screwdriver then the half that has the buttons will pop apart like a watch the battery is a watch/hearing aid battery, think the number is c2023