Overflow of gasoline and tuning caburator. how can analys if my caburator need to replace
SOURCE: my suzuki carry f6a wont idel
Before doing anything else . Check the idle air control valve. It is located at the hole in the fuel system side. It can be removed and cleaned. Or spray cleaned using carb cleaner.After removing the air duct work. With the engine on and running at 1200 rpms or so, spray cleaner directly at some holes in the sides of the hole going to the fuel system. turn off engine and let the cleaner soak into the valve.Repeat process. If that is not the problem. it may be the Idle position sensor, (IPS) it is located near the fuel systen with a plug of a few wires. remove the plug and replace the sensor.
SOURCE: engine number of suzuki F6a?
Try checking the engine block. The number is stamped right above the oil pan on the right side of the engine. there is the flat part of the block there. It's a little hard to see, you may need a wire brush to clean it out.
SOURCE: the cooling water of my F6a suzuki engine is mixing up to lubricating oil
If your head gasket is good, and you know this without a doubt, then you either have a cracked head/block or your head is warped. There is no other way for coolant to be getting in your oil. Heads aint any fun to take out and mess with but if you can do the work yourself it isn't to expensive to do. As long as your block is good. Good luck.
SOURCE: cooling water is mixing with my suzuki multicab f6a engine oil, cylinder head gasket is good
if oil cooler that uses coolant ck first if no oil cooler, internal gasket leak in front cover or water pump.or internal crack.
1,337 views
Usually answered in minutes!
×