1994 Toyota Corolla Logo

Related Topics:

A
Anonymous Posted on Oct 02, 2013

94 Toyota corolla cooling gauge not working. How can I this be fix?

5 Related Answers

Anonymous

  • 129 Answers
  • Posted on Jan 26, 2009

SOURCE: 1992 toyota Corolla Temp gauge does not work

find the wire that goes to temp sender and apply earth to it turn ignition on the temp gauge should read hot if it does replace water temp sender if gauge dose not move gauge needs replaging

Ad

Anonymous

  • 101 Answers
  • Posted on Aug 19, 2009

SOURCE: 1990 toyota corolla, fuel/temperature gauges not working.

If you are handy with small hand tools and a Volt/Ohm meter then it would be worth a try to check the problem, older cards the fuel guage is problematic. In the tank in a wire wound resistor connected to the float in the tank, every time you change the fuel lever the wiper rubs the wires and over time it either breaks or gets coated with crud, it requires removing the sensor from the tank and cleaning it. To test however you can follow the wires to the tank and remove the connector, if you have a fuel pump in the tank then you will need to check the wiring diagram for the correct wires and colors. You then measure the resistance across the two wires for the sensor, open circuit means the part will require removel and repair, anything from zero to about 120 means it is probably working, you can also short the wires going back to the gauge and turn on the ignition switch but don't start the car, if it read full then remove the short and it should read empty, the gauge is working. Temp gauge same process just the sensor is under the hood, same process measure resisitance. If you are going to try this yourself I suggest a service manual from your local parts store. If you choose to then take it to a mechanic you already know what to expect. I don't suggest removing a fuel tank alone, it requires jacking up the card and having something to raise and lower the tank. You are working with flamable liquids and you can be seriously injured or killed. Take care folow instructions and you will be fine. Wish it were simpler but this is what a mechanic is going to do as well.

Anonymous

  • 288 Answers
  • Posted on Aug 30, 2009

SOURCE: how to change a starter in a '94 toyota corolla

It's easier if you remove the air filter box and duct.

Frank
Frank's Friendly Cars Maui Car Rental
www.MauiCarRental.biz

Jonah Oneal

  • 14092 Answers
  • Posted on Oct 13, 2009

SOURCE: minimum brake disc thickness 94 Toyota Corolla

0.669 BRAKE DISC MINIMUM THICKNESS.

Anonymous

  • 563 Answers
  • Posted on Oct 21, 2009

SOURCE: my toyota corolla 94 window driver side can not scroll up&down

Perhaps a faulty window-motor, or the window switch.
Make sure your battery is good. Usually the problem is the window-switch.

Ad

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

0helpful
3answers

How do I remove fuel filter 94 Toyota corolla

Under hood, driver side, rear engine area, passenger side of master cylinder, mounted in fuel line ,
0helpful
1answer

Interchsnge yesrs or other make,/models for Starter in 1994 Toyota Corolla

If it's the 1.6 motor then 94 to 96 corolla take that starter only. But if it's a 1.8 motor then 94 to 97 take that starter and also geo prizm 94 to 97 takes that starter
0helpful
1answer

I cant find the fuel pump relay in a 94 toyota

relay should be inside the hood next to engine there is a fuse box cover stated what relay are uses.
0helpful
1answer

My toyota corolla 94 window driver side can not scroll up&down

Perhaps a faulty window-motor, or the window switch.
Make sure your battery is good. Usually the problem is the window-switch.
0helpful
1answer
0helpful
3answers

Temperature gauge is high but radiatior fan is working

how is the radiator and the thermostat?  Do the cooling fans come on?  Are you totally filling the cooling system and bleeding it?
0helpful
1answer

1992 toyota Corolla Temp gauge does not work

find the wire that goes to temp sender and apply earth to it turn ignition on the temp gauge should read hot if it does replace water temp sender if gauge dose not move gauge needs replaging
Not finding what you are looking for?

49 views

Ask a Question

Usually answered in minutes!

Top Toyota Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

15088 Answers

ROBERT GARCIA
ROBERT GARCIA

Level 3 Expert

926 Answers

Are you a Toyota Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...