2007 Chevrolet Suburban Stereo Wiring Information
Radio Battery Constant 12v+ Wire: Red/White
Radio Ground Wire: Brown
Left Front Speaker Positive Wire (+): Tan
Left Front Speaker Negative Wire (-): Gray
Right Front Speaker Positive Wire (+): Light Green
Right Front Speaker Negative Wire (-): Dark Green
Left Rear Speaker Positive Wire (+): Brown
Left Rear Speaker Negative Wire (-): Yellow
Right Rear Speaker Positive Wire (+): Dark Blue
Right Rear Speaker Negative Wire (-): Light Blue
Not sure if this helps or not, ypur question is kind ofconfusing.
Testimonial: "behind the factory radio are four harness plugins. One is black, one is gray, on is purple and one is brown. The brown is for the rear view back up camera. I need to know what the other three harnesses are."
SOURCE: 1998 Suburban Fuel Pump wiring harness
if its the correct harness then yes... i would follow colors.conecting the thinner black to the orange/black.
i have built and repaired wire harness' for four winds rv for 5 yrs now and previously gm cars for 4 yrs
SOURCE: We are replacing the fuel filter in a 98 pontiac
Assuming you mean replacing the fuel PUMP, the 2 wires are different guages. Connect the lighter wire to the lighter wire and the heavier wire to the heavier wire. If the new harness uses both the same size wires, the heavier wire on the vehicle side (solid black) is for the fuel pump ground. Lighter wire is for fuel guage sending unit.
SOURCE: the new connector for the fuel pump 99 Chevy
One wire will be a common ground. Depending on how much fuel you have in the tank you should receive a voltage from about 5 to 9 volts from the common ground to the fuel gauge - the other is the live to the Fuel Pump, typically - your 4 wire situation may be two grounds - one to each - put a fuse 10amp fuse in-line or disconnect the pigtail from tank and test for voltages and Zero resistance which would be the same as if you put both probes from your tester together and the meter shows "1" - if there is a problem or resistance then the reading will be "0" or the resistance value. Be sure to use low Ohms setting or you may not get any reading.
This is of course - general info, from which should lead you to the answer you seek.
Good luck.
East Coast Canada Rocks!!!
:)
Good luck.
There may be a ground that just connects to the tank itself - you can test for Ohms with a meter to determine if these are ground wires or must be determined. Can check between negative to battery to
263 views
Usually answered in minutes!
×