Question about 2001 Jaguar XJ
I can lift the handle but nothing happens, and now even the door won't open when you try from the inside
Drivers side rear door won't open. Both handles work, but the lock stays down. Even when you lift the lock peg the handles will not engange.
Locking and unlocking the car does not lift the lock peg.
You have something broke or not working inside the door. You have a huge problem. You will need to remove the door panel with it closed which is going to be hard to do. Once you can get into the inside of the door you will be able to inspect the linkage and figure what is the real problem inside. The door lock assembly will never work correctly till you find out if a clip broke and you can't know that till looking inside
Posted on Dec 02, 2017
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
Here's a link to this great service
Posted on Jan 02, 2017
only way to repair is to replace the handles. this is a common problem they use a toothed circle to work the lever and it wears and jumps a tooth basically and it will pop the tooth off if you push it back.so replacement is only fix
Posted on Sep 18, 2008
Take the door panel off the inside of the door. (Should involve screws at the bottom, plus bolts through the interior handle. Then pull out at the bottom, and lift upward Google for expedition door panel removal for more specifics if needed).
It sounds like the exterior handle linkage is binding against the lock button linkage. Actually looking in while pulling the handle would confirm. You then should be able to just bend the rods a bit to move them apart.
Posted on Mar 10, 2009
I have been dealing with the same problem and I'm a little further than you are. You need two people to do this job. Open the front door and it will give you access to the hinge pin. If I remember correctly you can pop off the snap rings and pull the pins. This will allow you to open the door just enough to get the interior panel off the door to allow you access to the actuator. Unfortunately, both my rear door actuators have been done twice in the last 5 weeks, But they are seized in the locked position again. I,m pretty sure its not just the actuators that are bad. Something else is causing this and that is why I'm here. Good luck with that one.
Posted on Aug 28, 2009
You more than likely will have to remove the interior panel on the door which will be fun and take some time. Once you have it removed you should be able to manually operate the linkage and get it opened. I would be ready to locate a new panel just in case you break the original one, but they usually have some give to them if you take it slow. You might try removing the speaker also if you have one in the back door. It might give you enough room to use a stiff wire with a hook bent in it to operate the linkage.
Posted on Sep 10, 2009
Tips for a great answer:
Oct 07, 2016 | Cars & Trucks
May 23, 2012 | 1992 Honda Accord
Apr 08, 2012 | 2005 Chevrolet Uplander
Mar 14, 2012 | 1997 Mercury Mountaineer
May 07, 2017 | 2001 Ford Windstar
Jun 03, 2010 | 1997 Toyota Avalon
Apr 07, 2010 | 2005 Nissan Quest
Dec 14, 2009 | 2004 BMW 3 Series
Nov 16, 2009 | 2002 Jaguar X-Type
78 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: