Creaking, squeaking sound going over bumps and uneven road surfaces and when turning wheel sometimes on a 95 Merc. Mystique

You can go to the 4S center to check if the brake is the right one .

Is this a suspension creak, or a door creak?

Components which you haven't had changed are:

bottom suspension arms
Anti roll bar links

Also lubricate your door lock mechanism, hinges and window rubbers as these can cause creaks from time to time.

Sounds like you have a speed sensor signal dropping out. This would cause the ABS system to falsely think one of the wheels has locked up and would turn on the abs to unlock the wheel.

You can visually check the wiring harnesses to the speed sensors to see if there are any corroded connections, corroded wires or broken wires. If everything looks good than the next step would be to drive it with a scan tool and watch ABS data. You should be able to spot the speed sensors that drops out on the scan tool when the problem occurs. Than you can focus on that wheel to see what the problem is.

I’m happy to assist further over the phone at https://www.6ya.com/expert/jeremy_d728a59f986299fa

sounds like worn out shocks or struts

u have a rock or something wedged between ur frame and cab

That noise sounds to me like a Ball Joint problem. I would check to see if you have fittings to grease the front suspention.

Good luck, Allen

Sounds like it is your CV axles.  Turn the wheel one direction, right or left, and check just behind the wheels to see if your CV boot is cracked or ripped (the boot is a black, rubber accordion looking thing).  If it is cracked or ripped, I would say that is definitely the problem.

I had the same problem with my 01 suburban. It was the struts. Replaced them and no more squeaks!!

It can be from both the struts and any piece of frame or body that has a rubber mount.(most likely struts and A arms making the noise)


Please rate this a fixya

There's a chance that the ball joints need grease. This should help, however once they have started to make noise like that due to lack of grease, they usually have gone bad. Replacement may be the only remedy. Hope this helps.