SOURCE: I have A 2000 Chevy 3500 Express Van and the brake
Hi,
When you said that you checked the brake switch, did you check it live? Meaning verified live power to the switch, press switch, and then power came out the other terminal?
If so, also verify zero power on brake press, at the offending brake light bulb terminal. You must verify the test light each time you move it...leave running lights on...
After verifying that there is no power coming, after the brake is pressed, note the wire color and find it where it comes to the steering column and test there... This would eliminate wires and connections between front and the rear of the vehicle, unlikely, but needs to be tested.
After verifying no power at that terminal, then yes the t/s switch is certainly suspece. This may be the time to get a mechanic to verify and replace the switch, there are locks, tilt mechanisms, air bags, column bearings, etc involved. Failures risk loss of vehicle control (locking or binding for example.)..
Hope this gets you going in the right direction.
Testimonial: "Thank You. I tried those things and it seemed to be the Emergency Flasher switch in the multi function switch."
SOURCE: Where is the turn signal flasher located on a 1995
On the fuse block with the other fuses below the dash
SOURCE: 1997 Chevy Tahoe both turn signals stopped working
Sounds like the flasher unit to me. Normally the emergency flasher and turn signal are separate.
SOURCE: brake cab light works , no bed brake lights ,
Had the sam thing happen on my 95 GMC.There was a part under the dash to the reear of the parking brake were all the relays were pluged in that looked like the old buzzer box.Not sure the name of it or if yours will have the same retanguler box.Has something to do with the brake lights.The guys at my local napa new what part it was but never caught the name of it,was just happy to have brake lights again.
SOURCE: 95 suburban. turn signals not
it could be a short if you have trailer wiring, try unpluging the wiring and see if that works, be sure you looked at the right flasher the hazards and flasher have diffrent flasher units. its possible to have a bad turn signal cam, or a malfunction in your hazard switch.
814 views
Usually answered in minutes!
×