My turn signals and flashers are not working on my 2001 subaru obw

The turn signal flasher unit is bad.

Sounds like you have a bad turn signal switch, unless you ahve the emergency flashers on and one side is not working. turn on the emergenvcy flasher and make sure both sides work. if they do, you have a bad switch

I had this problem with my car. Is ur hazzard flasher working? if they are working and the turn signals are not working. Try replacing the hazzard light switch. If the hazzard are not working then the combination flasher unit is bad. its what controls the signals and flasher.

are you sure you don`t have a bulb filament that is making and breaking contact causing the flasher to intermittently work.assuming you mean they either stop flashing or flash faster than normal.when the flashers are working look under the dash and find the flasher unit with it operating.all you have to do is pull the flasher out of its location and install in reverse.i say check with the signals working because the hazard flasher looks the same but is a different unit.

there is no turn signal flasher or relay, its a combination switch, but there is a fuse, in the fuse box under the dash, the fuse isn't mark well, but says;

BACK
TURN
(4WD-AT)

if you have a gl-10 this fuse also controls power windows,
i had this same issue where my turn signals and my power windows stopped working (but my hazards still worked) and changing this fuse fixed all my issues

most likely fuse, flasher relay, or mechanical problem in turn signal switch at steering wheel. Do emergency flashers work? also check bulbs and sockets for corrosion...

Sounds like the flasher unit to me. Normally the emergency flasher and turn signal are separate.

the problem most likely exist in the signal lever. Check and trace your wiring from lever to flasher

they are usually one and the same box fuse...you might try putting in a new one

The flasher is behind the trim panel under the steering wheel, it is an electronic module.