-
Contributor
5 Answers
- Posted on Apr 18, 2009
Re: HORN DID NOT WORK SO WENT AND GOT A FUZE PUT IT IN...
A fuse always blows for a reason. The reason your fuse must have blown was because of a short to ground in the horn switch. That means the power side of the horn switch is currently touching ground or metal or that the switch is bad on the inside. The more remote possiblity is that you have a short somewhere in the wiring harness. It is always typical for a component to go bad before a harness.
Here are some notes directly from chrysler, let me know if you need any clarification:
Testing and Inspection
Notes
WARNING: ON VEHICLES EQUIPPED WITH AIR-BAGS, REFER TO AIRBAGS AND SEAT BELTS/AIRBAGS BEFORE ATTEMPTING STEERING WHEEL, STEERING COLUMN, OR INSTRUMENT PANEL COMPONENT DIAGNOSIS OR SERVICE. FAILURE TO TAKE THE PROPER PRECAUTIONS COULD RESULT IN ACCIDENTAL AIRBAG DEPLOYMENT AND POSSIBLE PERSONAL INJURY.
- Disconnect and isolate the battery negative cable. Remove the lower steering column cover/knee blocker. Check for continuity between the metal steering column jacket and a good ground. There should be continuity If OK, go to Step 2. If not OK, refer to Steering and Suspension/Steering Column and check for proper installation of the steering column mounting nuts.
- Remove the driver's airbag module. Unplug the horn switch wire connector. Remove the horn relay from the Power Distribution Center (PDC) . Check for continuity between the steering column half of the horn switch feed wire connector and a good ground. There should be no continuity If OK, go to Step 3. If not OK, repair the short circuit as required.
- Check for continuity between the steering column half of the horn switch feed wire connector and the horn relay control circuit cavity for the horn relay in the PDC. There should be continuity If OK, go to Step 4. If not OK, repair the open circuit as required.
- Check for continuity between the horn switch feed wire and the horn switch ground wire on the airbag module. There should be no continuity If OK, go to Step 5. If not OK, replace the faulty horn switch.
- Depress the center of the airbag module cover and check for continuity between the horn switch feed wire and the horn switch ground wire on the airbag module. There should be continuity If not OK, replace the faulty horn switch.
YES WE TRIED THE HORN RELAY
have you tried checking the horn relay?
horn button sticking?, disconnect it and see if it stops.
×