Have a compression check done on the engine If the motor spins faster then that indicates a compression problem form no resistance in the motor.
SOURCE: Where is the starter on a 1995 Mazda MPV van?
it is located under the skid plate. you'll need to remove the front drive, the alternator, and power steering pump out to remove the starter. need to remove the bottom cover to see it.
SOURCE: 1997 Mazda MPV, 3-Ltr. V6, destroys Timing Belt
i need help install a timebelt in a mazda mpv? please help me out
SOURCE: 2004 Mazda MPV vacuum line from pcv valve and
You have the wrong type hose on the pcv valvle. It isn't vacuum hose.
Testimonial: "thank you you have been very helpful i understand now but the hose that is on the new pcv valve is a vacuum hose "
SOURCE: Have a 1997 mazda mpv just quite running. After
Hello handy randy.
The 3.0 liter engine in your Mazda is classed as an interference engine.
Some are more tolerant than others to bending valves.If it happened on the road it is quite possible damage was done unfortunately.
If you have access to a bore scope it is a quick way to have a look to see if damage was done.
Hope you fare out OK.
KL
Testimonial: "Thank for your help. Was going slow so i went ahead an changed the belt an water pump. Runs great. Thank Again Randy"
SOURCE: I want to locate the starter motor on 1991 mazda
The starter motor on the MPV is located on the underside of the engine on the passenger side. If your MPV is four wheel drive it will be virtually impossible to see even if you are lying on your back under the vehicle. If you plan to take it out let me know as I have some experience with this situation.
You will need a new starter rebuilt ect. to replace the one you currently have that is defective. you sound like you are spinning the starter motor but the starter bendix is no longer engaging the flexplate/flywheel on the engine.
193 views
Usually answered in minutes!
×