What size belt will u need to bypass the air compressor on a 2004 crown Victoria

SOURCE: where can i locate the air suspension compressor

most of theford air compressors are located towards the front of the fender wheel well in the bottom corner some times under the plastic water tanks

SOURCE: replace 2004 Crown Victoria headlight

From the engine compartment, unlock the 3 tabs that are over the headlight housing area. Remove the cover and unscrew the plastic ring that has the wires protruding from it. Carefully pulls the light fixture out of the housing. Pull the 2 L-shaped tabs up and remove the lens section. Reverse the steps to re-install the headlight. If replacing the full turn signal housing, unscrew 2 screws from each light , disconnect bulb wiring and remove. Replace accordingly.

SOURCE: I need to know what size belt do i need to bypass

use a piece of string to measure around the pulleys then take the string to your supplier and get a belt that suits.......

SOURCE: air compressor locked up what alternative vehicle belt can i use to bypass the a/c compressor on a 1999 crown victoria

does the diagram of the belt routing on the core support say one with ac and one w\o ac? if so autozone can tell u, if not, they may tell u that you need to replace the ac compressor, or buy some thing that re routs it. you can also try to remove the compressor, that way its out of the way, and take a string, run it as it would go, and measure the string, that will tell u what size belt to get