Need frame or frame parts

https://www.ebay.com/itm/144103697147

THE CONVERTIBLE TOP FRAME WORK NEEDS LUBRICATION USING PENETRATING OIL AND THE FRAME WORK NEED ADJUSTMENT.SOUND LIKE ITS BINDING.DISCONNECT HYDRALIC CYLINDERS FROM THE TOP FRAMEWORK AND OPERATE TOP BY HAND.TOP SHOULD GO UP AND DOWN SMOOTHLY WITHOUT RESISTANCE.IF SO FRAME WORK WILL NEED ADJUSTING.

no, this is one of those situations where you either have the parts to splice it back together or you need to replace the whole line. . Its a dealer part unless you can remove it and go to a autoparts house and match it up.

Item Part Number Description 1 52 Exhaust Inlet Pipe 2 N803420-S2 Exhaust Manifold-to-Inlet Pipe Bolts
(4 Req'd) 3 5E212 Three Way Catalytic Converter 4 5230 Muffler 5 N620482-S2 Exhaust Inlet Pipe-to-Converter Nut
(3 Req'd) 6 5B266 Exhaust Converter Inlet Pipe Gasket 7 N620481-S2 Nut 8 5E269 Exhaust Converter Frame Bracket 9 N620481-S2 Nut 10 5260 Exhaust Outlet Pipe Frame Bracket 11 5E269 Exhaust Converter Frame Bracket 12 39006 Screw and Washer 13 5E241 Exhaust Converter Outlet Gasket 14 5G215 Exhaust Pipe Flange Hold Down Spring 15 N802641-S2 Nut and Retainer 16 — Rear Heated Oxygen Sensor (HO2S) A — Tighten to 34-46 Nm
(25-34 Lb-Ft) B — Tighten to 20-25 Nm
(15-19 Lb-Ft) C — Tighten to 34-46 Nm
(25-34 Lb-Ft)

See if floor pan is cracked,seat frames do crack on these, inspect better around welds and riveted areas. see back rest frame too for cracks

Body & Frame Hardware Parts (corvettemods.com)

Its possible, myself i think it would be easier to put the sheetmetal from the 70 onto the 79 frame, but you can do it either way, but you might need a torch and welder, and a good drill and drill bits, i think if the cab mounts from the 70 match up with the mounts on the frame of the 79 it would be easier to switch the cab, box, and front end off the 70 to 79. there isent enough room here to explane everything, if you got questions i got answers. Just ask.

You can Repair a Bent Frame. There are Frame Shops all over the US. Check the Online Yellow Pages for Automotive Frame Straightening. Prices Vary from State to State But, It is notPlease Rate my Solution, I need all the Help that I can Get! Thanks! Cheap.

the only way to do it is put your cab and box on a 4x4 chassis.
the frames are different.

You will need to visit an auto salvage yard.
The same top will fit from any 90-93 Geo Metro, Suzuki Swift or Pontiac Firefly.

Karl at topgunwon.com