Replacing the egr valve on 2005 dodge durango
If this is a 4.7l engine, the valve is on the left rear of the intake. loosen the 8mm bolts that hold the egr intake tube to the egr valve, remove the egr bolts, disconnect wiring, remove valve and tube together, attach intake tube loosely to new valve, install new valve, tighten tube bolts to egr using a swivel socket, this is not a 5 minute job, so dont attempt unless you have some time and patience.
2000 dodge durango, wont idle when first started in morning. Once it has warmed up (few minutes) then runs fine.
SOURCE: Location of EGR valve on 2005 Dodge Durango
If I had been him, I would have talked you into a Chilton or Haynes manual for your car. They are easily detailed enough to show you the location and Iwould be surprised if a chain operation like AZ didn't have the right one on hand.
SOURCE: EGR Valve 2005 Dodge Durango
Check in the drivers side rear of engine take off the air housing and use 13mm. deep
socket w / 3inch ext. and air ratchet to remove 2 bolts, then take tire
off inner splash panel then 8mm wobble w / 24inch ext to take 1 tube bolts
loosen other one and pull out as ***. Reverse to install.
Hope this help to solve it (remember rated this post).
SOURCE: how to replace the egr
Dont bother just make a seal off gasket from a coca cola can ,it will run better without the EGR valve and still pass the emmisions test with it blocked off
3,436 views
Usually answered in minutes!
horn won't stop dodge durango 2005
how do i connect my speaker wires for a Dodge Durango 2005
how do i connect my speaker wires for a Dodge Durango 2005 radio
where does my radio speaker wires go for my Dodge Durango 2005
×