Change cam and crankshaft sensor and still in the diagnostic problem cam sensor
SOURCE: Crankshaft Position Sensor location 04 PT Cruiser
It is located behind the **** of the starter on the front of the engine starting in '03 the 2.4 lt was changes the repair manual failed to update this..you may sneak it out with small fingers with out pulling out the starter.
SOURCE: 2004 chrysler pt cruiser starter motor removal
You may sneak it out with small fingers with out pulling out the starter.
If starter removal is required,Just unhook the battery cables,Remove the 2 bolts holding the starter on.
Please rate this a fixya
SOURCE: where is the crank sensor located on 2005 chrysler pt cruiser?
the crank sensor is located on back right side of engine by were the trans. bolts up.is the no start when could or hot?
687 views
Usually answered in minutes!
Change the crankshaft position sensor and starter is working fine, have it tested at autozone... And still the same no crank in the starter...
There's no check engine... and i think its the antithief relay is not connecting i mean the contact point is not connecting when i'm trying to start...
×