SOURCE: 1998 Land Rover Discovery Series 1
You can energise the interlock solenoid, by you give a positive (+12V) lead to the RED and a negative (ground) to the black line at the transmission selector's connector.
If it works you should check the positive signal at the red.
It should be there if the ignition is on, brake pedal depressed, and the transfer box is in some gear, and the fuse 1 isn't blown.
At the black cable should be a ground signal if the selector in 'P' position.
If you give me an e-mail address I'll send the wiring.
The ABS problem, you have better to check followings.
- All the wheels bearings' play.
- are the ABS sensors at the deepst position? Knock some to that head (not strong) and they shouldn't move deeper.
-land rover repair
SOURCE: Radio in 2000 Land Rover Discovery
THERE SHOULD BE A RADIO CODE CARD WITH THE VEHICLES PAPER WORK.IF NOT U HAVE TO CALL THE DEALER FOR THE CODE.
SOURCE: what is code p1496 check engine light error mean
OBD code P1496 - low sensor output voltage (4v or less for 4 seconds)
SOURCE: 2004 land rover discovery, ignition
it sounds like your starter motor is faulty. first make sure the battery is fully charged, then place a screwdriver between the contacts of the solenoid on the starter motor, if it again just clicks, then you need to repair or replace the starter motor.
hope this helps
SOURCE: 97 Land rover discovery 1 oil light comes on after approx. 15 mil
Tune-Up-Parts Link:
http://www.britishpacific.com/BPSite/LandRoverDiscovery/DiscoIService.html
Testimonial: "Great site for Land Rover parts. Thanks for the suggestion."
139 views
Usually answered in minutes!
×