Question about 2000 Volvo S80
The gas filter is located passenger side just forward of the rear axle. The band that holds the gas filter in place is a pinch band that has a nut welded/formed into it on the back/top side. A 12 mm bolt holds the band in place. The top of the band has a bracket that hold the return fuel line - this just pops off and the return fuel line can be reattached once the filter has been replaced. If your filter has never been replaced there is masking tape covering the pinch connections at both ends of the filter. Remove the masking tape. You need to put a pan under the old filter to catch any gas spillage - it will be minimal. Also the new filter comes with plastic caps on the ends of the new filter - you will want to use them to plug the old filter connectors so you need to take them off the new filter to have handy. Ther is a T off the inlet gas line that has a cap on it - remove the cap and press the needle in the T to relieve any pressure that is on the gas line - If it has been setting for an hour there will probably be very little if any pressure on the line. You can skip messing with the T and you will see about an ounce of fuel that will come out of the filter when you remove the hose.
To remove the connectors push the connector ring away from the filter housing. (I did the front first because I had more room). I used a paint can opener to help pry the hose away from the filter - it is shaped like a can opener but without a cutting edge - a large flat screwdriver would perform as well. It is a tight fit but once it starts to move it will come off. Once the hose is off use the plastic caps you took off the new filter to help hold the gas in the old filter. After removing both ends remove the holding band and place it on the new filter. The two lines will go back on easier than they came off, just push them onto the filters nipples. Put the 12 mm OR 10MM bolt back into the pinch band and reintall the return fuel line.
Posted on Aug 18, 2009
I had the 1998 model. if I remember correctly. the hoses connecting to the ends of the fuel filter for this car are like quick connect couplings. the soft rubber at the ends pulls back and then you can pull the hose off. it kinda clicks on.the ends of the hoses had masking tape wrapped around them keeping silicon grease lubricant on the hose ends I guess so they would dry rot . hope this helps
Posted on Jun 24, 2009
Just in front of rear wheel under car
Posted on Jul 07, 2009
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
Here's a link to this great service
Posted on Jan 02, 2017
Copied from Volvo Forums
I had a similar problem w recently bought 2003 S80.Several points: 1) Access your locking selonoid through the trunk interior panel ... loosen a few hex bolts and slide out for maintenance; 2) I fixed my lock by simply using light teflon-based oil (like for bike chains). I exercised it a few times and it works beautifully; 3) Not sure on your model, but gas door on the '03 unlocks when you push the associated release button under the headlight control switch. It is not designed to unlock w the key (again, check owners manual for your year). Hope this helps. master_pre08-04-2007, 09:35 AMYeah, the fuel door on my 2000 S80 is connected with the door locks. In order for it to open you have to unlock all the doors to the car. Sssnake08-14-2007, 03:39 PM Thanks Guys,
I removed the locking mechanism and applied a little silicon graphite and now it works like a charm.
Posted on Jun 07, 2010
Tips for a great answer:
Dec 03, 2015 | 2000 Volvo S80
Oct 04, 2015 | Volvo Cars & Trucks
Sep 28, 2015 | Volvo Cars & Trucks
Apr 15, 2014 | 2000 Volvo S80
Aug 15, 2012 | 2000 Volvo S80
Apr 01, 2011 | 2000 Volvo S80
Apr 10, 2010 | 2000 Volvo S80
Nov 20, 2009 | 2000 Volvo S80
Dec 21, 2008 | 2000 Volvo S80
Oct 12, 2017 | 2000 Volvo S80
3,549 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: