How do i fix the problem with aid of diagrams
This DTC code is a
result of a mechanical fault of the VCT unit or related components, so
there is no need for electrical diagnosis.
Refer to vehicle specific
repair manual to perform component tests for the VCT unit.
Notes: Dealer
techs have advanced tools and the ability to follow detailed
troubleshooting steps, including the ability to test components using a
scan tool.
Read more at: http://www.obd-codes.com/p0011
Copyright OBD-Codes.com
SOURCE: check engine lights is p0011 how do I fix this problem
I looked up the code you posted, and came back as the camshaft position sensor, which is behind the timing belt cover, if it is the right model.
SOURCE: volvo 2002 S80 T6 - codes P0011 and P0011
Weell it sounds like you have the days old problem Pepole dont know how to look after there cars.
The muck you still have in the engine isent doing it any good and so you have to get rid of it all, as its in the engine block and is got to go ,,so drain a little of water out and put in 1/2 a cup of washing up liquid in the radiator and start the engine and let it get hot and take the reves up to 1000 rpm now and then to keep the water going around the system, after about 1/4 hr turn off,,stand for 10 minutes ,,and then remove the cap slowly and then take off the Bottom hose and let all water out also take off Top hose at the engine end and put the house water hose in the top and turn it on till all water comes out clean. Then put hose up into the bottom hose and do the same again ,and the same in top again.Now with a clean engine you can do the same to the new Radiator and wash out all gunk .then check the thermostat and make sure its 100% (any doubt through it out) and take note how it comes out so you can fit a new one the same way,
Now refit both hoses and fill with coolant or antifreeze and TURN on the heater to hot before starting as you also have to get out the air from heater when it was drained and you will trap the air which might cause you code problems..
But now try service light reset
1,,Turn Ignition to Number 1position.
2,,Press and hold "day counter"reset button and turn
ignition to II(second) position,hold down for about 12 seconds.
3,,Afterservice light flashes,release button,there should be 2 beeps confirming reset was successful.
Let me know how you get on .. Ron
SOURCE: I have the code p0011,what is that?
Its a cam position timing sensor alert.
Usually if you have an oil change and code reset it stops coming up.
SOURCE: P0011 code found when service engine light came
I would try to replace the Crankshaft or Camshaft sensors. Hope this helps.
659 views
Usually answered in minutes!
×