Headlight globe change Magna 2000 TJ Wagon

I think you should buy repair manual first for your vehicle after that it will be easy for you to solve the problem. Check the link may be you will find something useful here
Complete Mitsubishi Magna 1998 2001 TH Series 1998 2002 TJ Series Verada...

Mitsubishi change side lamp bulb mitsubishi space wagon ...

www.fixya.com > ... > change side lamp bulb mitsubishi space wagon

Change side lamp bulb Mitsubishi space wagon related problems. Ask your Change side lamp bulb Mitsubishi space wagon questions. Get free help, advice ...

Mitsubishi Space Wagon 91 98 Sidelight Bulbs W5W 501 ...

www.ebay.com > ... > External Lights & Indicators > Bulbs & LEDs

eBayProduct Type: Sidelight. Operates: Sidelight. Further Information: These bulbs are a direct replacement for any W5W 5W (501) wedge bulb no matter what brand.

I would disconnect the battery and reconnect it should reset it

The headlight globe usually just twists out of the back of the headlight assembly. When fitting the new globe,use a cloth or glove. Don't touch any part of the globe with bare hands as the oily film will cause the new globe to fail very quickly.

take it to a place that reads codes for free.. see what it shows..

Check the mount,s and drive shaft first.

You either have hands the size of an 8 year old child or you have never done this yourself. There is no way to access the connector and manipulate the connector release tabs to remove the globe on the drivers side with the assembly in place, with all the plumbing and water bottle in place. You have to remove the whole front bumper and associated guards etc etc just to replace a globe. Very poor design.

open the bonnet, locate a screw on top of the headlight and undo it, locate two screws between the centre grill and headlight and undo them and locate a screw right behind the headlight assembly and loosen it. Now the whole headlight should come out. It wont come all the way out. By unplugging the electrical plug you can take it out completely. Lift up the lock thats hold the rear headlight cover and that will expose the internals of the headlight and then you can change whatever globe you want. First disconnect the wiring plug from the globe and then release the clip holding the globe and replace the globe and make you sure you dont touch the glass part of the new globe which installing. Touching it will shorten the globes life and there is a chance that it might explode inside and create mess. You need to buy H7 type globe for low beam.

if you dont see any(look real hard) then you probably can just pull up or out and it will just come out,Some dashes after 2000 are pushed in type.

they just pop in on the mits model remove the neccesary bolts and **** it out one at a time though dont take both out or youll need a new trans to to put it back it firmly pop it in