I need to remove the inside door panel on a 91 Gmc Sierra

Hello,

There's in usually two ways to remove a car door. Either the hinges bolt to the frame of the car, OR they bolt to the inside of the door. In some cases they are welded in place, but that's pretty rare. If you can open the door, look in the door jam snd you should see the bolts. If you don't, try removing the interior door panel and look on the inside of the door (towards the front) and you should see them there. I'm sure the window frame will have to be in the "up" position. Good luck.

sorry but the panel needs removed, go on be brave its not all that hard to do .adrian,,

On the inside trim, you can remove screws (these screws may be covered by filler pieces or may be visible, or they may require you pry a plastic piece off that covers the screws) that are by the door handle, arm rest, under door and side of door and then gently pull back on the panel as there will also be retaining clips attached and you don't want to break them. You'll need to lift the door panel upwards in order to get it off the window ledge. Then you'll need to manipulate the panel and disconnect the door handle linkage from the door handle and disconnect any other wiring that may be attached to the door.

NO' YOU DONT NEED TO REMOVE THE ENTIRE DOOR PANEL, TO REPLACE SPEAKERS CONNECT WIRING CONNECTOR TO SPEAKER FIT SPEAKER BACK IN GRILLE AND REPLACE RETAINING SCREWS.

On the inside trim, you can remove screws that are by the door handle, arm rest, under door and side of door and then gently pull back on the panel as there will also be retaining clips attached and you don't want to break them. You'll need to lift the door panel upwards in order to get it off the window ledge. Then you'll need to manipulate the panel and disconnect the door handle linkage from the door handle and disconnect the wiring for your controls. Then you can put the new handle in and reconnect everything

On the inside trim, you can remove screws that are by the door handle, arm rest, under door and side of door and then gently pull back on the panel as there will also be retaining clips attached and you don't want to break them. You'll need to lift the door panel upwards in order to get it off the window ledge.

just remove the panel inside at the side of the mirror, then you will find the bolts.

DO you have power windows or manual. If you have standard cranks then you have to remove the clip holding it to the mechanism inside. if not then there are several screws in the door panel itself. remove all of them. Pry out the bottom of the door there are plastic buttons that should stay with the panel. then lift the door panel straight up the top is hooked inside the window trim. its stiff. but it comes out. The buttons are reusable.

You'll need to remove screws that are by the door handle, arm rest, under door and side of door and then gently pull back on the panel as there will also be retaining clips attached and you don't want to break them. If needed, you can pull back the weather seal (can't reuse it, but it's not that important) and you will be able to access everything inside the door

http://www.autozone.com/shopping/repairGuide.htm?pageId=0900c1528008f768
Hope this helps!