Speed sensor Where is the speedometer sensor located?

speedometer runs with several sensors cluster fuse if nothing works in cluster on key on cycle but speedometer uses both vehicle speed sensor and right front wheel speed sensor to operate . Vehicle speed sensor is located on top of transmission near right axle shaft

Speed sensor for the ABS system or for the speedometer?

If the speedometer and it is four wheel drive than the speed sensor will be in the rear housing of the transfer case.

I’m happy to assist further over the phone at https://www.6ya.com/expert/jeremy_d728a59f986299fa

its located on transfer case rear end near propeller shaft , have 3 wires plug

the speedometer sensor is located at the rare end the the transmission

NO, IT'S NOT THE TRANSMISSION! SOUNDS LIKE A SPEEDOMETER PROBLEM! THAT WOULD BE ONE OF THREE THINGS! EITHER THE SPEEDOMETER, THE CABLE, OR THE SPEED SENSOR! THE SPEED SENSOR WILL USUALLY GIVE YOU A P0500 CODE ON AN OBD-II CODE READER! THE SPEED SENSOR IS ELECTRONIC SPEED CONTROL LOCATED ON THE TRANSMISSION! SOME HAVE A SPEEDOMETER CABLE HOOKED TO THEM, AND SOME JUST HAVE A 2 WIRE PLUG THAT HOOKS TO IT!

Hyundai VSS locations:
On 1999-2003 vehicles, the vehicle speed sensor is built into the speedometer. On 2004-2005 vehicles, the vehicle speed sensor is attached to the output shaft of the transaxle.

On 1996-2003 vehicles, the vehicle speed sensor is built into the speedometer. On 2004-2005 vehicles, the vehicle speed sensor is attached to the output shaft of the transaxle.

On 1999-2003 vehicles, the vehicle speed sensor is built into the speedometer. On 2004-2005 vehicles, the vehicle speed sensor is attached to the output shaft of the transaxle.

Hope helps (remember rated this).

LEVEL CHECK -manual transmission The vehicle speed sensor (speedometer gear), which is located on the transaxle, serves as the manual transaxle's dipstick.

1. Park the car on a level surface, turn the engine OFF and apply the parking brake.
2. Locate the speedometer cable assembly where it enters the transaxle.
3. Unplug the electrical connection from the vehicle speed sensor (speedometer gear).
4. Disconnect the speedometer cable from the speed sensor.
5. Wipe the area around the speed sensor with a clean rag, then loosen the speed sensor retaining bolt.
6. Gently pry the speed sensor from the transaxle. Fig. 1: Location of the manual transaxle's fluid level marks — 1.8L engine
   Fig. 2: Location of the manual transaxle's fluid level marks — 1.9L and 2.0L engines
   
   
7. Check the condition of the speed sensor O-ring and replace it if it is damaged.
8. Check the fluid level on the speed sensor as illustrated.
9. If the level is low, place a funnel in the speed sensor hole.
10. Add the specified fluid to the transaxle until the FULL level is reached. Do not overfill the transaxle.
11. Install the speed sensor and tighten the retaining bolt to 69–104 inch lbs. (8–12 Nm).
12. Connect the speedometer cable.
13. Engage the speed sensor electrical connection. Fig. 3: If necessary, add transmission fluid through a funnel into the speed sensor opening
    

The vehicle speed sensor is located below the air cleaner assembly, it is held in with one bolt (I believe 10mm):

1. Remove the bolt and vehicle speed sensor assembly.
2. Remove the clip and speedometer driven gear from vehicle speed sensor.
3. Remove the O-ring from vehicle speed sensor
4. Coat a new O-ring with ATF and install it to the vehicle speed sensor.
5. Install the speedometer driven gear to the vehicle speed sensor and clip.
6. Install the vehicle speed sensor assembly and torque the bolts. Torque: 16 Nm (160 kgf-cm, 12 ft. lbs.)

The speed sensor is located behind the dash.

The speed sensor is located on the transmission