Obd connector picture

OBD2 connector location in Nissan Rogue (2014 - ...) - Outils OBD Facile
https://www.outilsobdfacile.com > location-plug-connector-obd > Nissan-r...

Easily find where your OBD2 port / connector is located in Nissan Rogue (2014 - ...) using our search engine.

Some versions use another location. It is on the knee panel on the driver's side. It is a 'clip in' cover plate just below the dash switch's between the steering wheel and the door. Attached is a photo to use for reference.

under the hood behind your DRIVER-SIDE strut tower... see pictures...

BBBind.com

1987 240 volvo obd plug location Bing images

BBB Industries Premium Alternators Starters Power Steering Products

OBD2 connector location in Suzuki Grand Vitara (1997 - 2005)

www.outilsobdfacile.com/...plug-connector-obd/Suzuki-grand-vitara-2
Easily find where your OBD2 port / connector is located in Suzuki Grand Vitara (1997 - 2005) ... OBD connector location for Suzuki Grand Vitara (1997 - 2005).

Suzuki Engines Diagnostic Connectors

codes.rennacs.com/Petrol-Engine/Japanese-Korean/Suzuki-Engines.php
Suzuki Engines - diagnostic connector locations, with detailed diagrams, text, and pictures of where to find the diagnostic connector in the vehicle.

Hi Chad,

Here is a follow up for you. The picture provided is from a 2005 with the OBD location. http://www.obd-2.de/carcode/pics/dlc/ford/Mercury-MarinerHybrid-2005.jpg .

Looking at many examples on line from all applications. The majority of these plugs are under the steering column. Either right or left mounted under the dash board.

On some foreign models . Remove the droor between the center console. And it will be mounted on the floor between the seats.

Fare . Well.

look on your driver side down below the dash toward the left you would see a little connector to plug into

It is under the dash on the drivers side, get under there and look, you will see it. Here is a picture of a typical OBD 2 connector plug.

On the1995 Jeep Cherokee, the OBD1 connector is located in the engine compartment on the left side, between the air cleaner and the computer module. It's a funny looking plug, not the standard OBD connector.

Here is a photo of the obd connector on a 1993 Isuzu Trooper.

The connector is on the transmission hump about 6 inches from the accelerator pedal. It is inside a black hood. Right next to the white OBD connector is an identical green connector that I have not tested.

The OBD port is a white 3 hole plug. Right next to it in the photo is a green 3 hole plug that I believe is for automatic transmission diagnostics. The plug is different from other plugs under the dash as it will not accept a .25" tab connector.

The picture shows a 20 ohm resistor being used to short pin 1 and 3 of the white plug. The resistor is to prevent a melted wire in case the plug shorted is the wrong plug.

To read the error codes from the engine computer, the mechanic is supposed to short pin 1 and pin 3 of the OBD port plug. Then the mechanic turns on the ignition switch and counts flashes of the "check engine" light to determine the error values being reported.

It is located near the center console. Here is a picture.