License plate light replacement

Fuse, shifter reverse switch or blown bulb(s). Start with the bulbs ...

My guess is one of those lamps is burned out, therefore not sending current to the next. My second guess is that the license plate light is last in line, so I would start with the left tail light

The licence plate doesn't have a fuse, it comes on when you put your lights on, if you have your park lights on and the plate light isn't working then generally it's just a bulb, see what you can find, cheers good luck

water is getting in the light housing,use some sealer in the housing went you change the light.

I presume you have your head lights on when you are checking the running lights ...

Replace the burned out license plate light

I just had the same problem. I took the cover off, saw the white bulb base, twisted it to take it out, but it popped back inside the door. I got it out, but it wouldn't pull through, so I twisted it back in place and went to Autozone to get new bulb. Once I saw the new bulb, it was obvious, just the bulb itself pulls out. There's so little room to work, I couldn't get it with just my fingers - - maybe rubber gloves would have worked, but I used pliers, lightly, wiggled it a little and it popped right out. I had a similar issue once with the taillight bulb and had to break the bulb and then grip the remaining filament wires with pliers to get it out, so that was my backup plan, just in case.

Hope this helps others.

there is none, will have to replace lights, should came on with running or parking lights.

when you put your parking lights on they should come on, if not you must replace them.

Just pull bulbs straight out be careful not to beak bulb

check and make sure the bulbs are not loosing their ground