Question about 2008 Volvo S80
Posted by Anonymous on
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
Here's a link to this great service
Posted on Jan 02, 2017
Weell it sounds like you have the days old problem Pepole dont know how to look after there cars.
The muck you still have in the engine isent doing it any good and so you have to get rid of it all, as its in the engine block and is got to go ,,so drain a little of water out and put in 1/2 a cup of washing up liquid in the radiator and start the engine and let it get hot and take the reves up to 1000 rpm now and then to keep the water going around the system, after about 1/4 hr turn off,,stand for 10 minutes ,,and then remove the cap slowly and then take off the Bottom hose and let all water out also take off Top hose at the engine end and put the house water hose in the top and turn it on till all water comes out clean. Then put hose up into the bottom hose and do the same again ,and the same in top again.Now with a clean engine you can do the same to the new Radiator and wash out all gunk .then check the thermostat and make sure its 100% (any doubt through it out) and take note how it comes out so you can fit a new one the same way,
Now refit both hoses and fill with coolant or antifreeze and TURN on the heater to hot before starting as you also have to get out the air from heater when it was drained and you will trap the air which might cause you code problems..
But now try service light reset
1,,Turn Ignition to Number 1position.
2,,Press and hold "day counter"reset button and turn
ignition to II(second) position,hold down for about 12 seconds.
3,,Afterservice light flashes,release button,there should be 2 beeps confirming reset was successful.
Let me know how you get on .. Ron
Posted on Nov 02, 2009
As always use extreme caution when lifting vehicle, but I have found that the easiest way to lift my car for oil change is to put jack under the cross member under engine.
Posted on Apr 04, 2010
Tips for a great answer:
Aug 19, 2018 | Volvo Cars & Trucks
Oct 16, 2017 | Volvo Cars & Trucks
Dec 05, 2013 | Cars & Trucks
Dec 23, 2012 | Cars & Trucks
Dec 01, 2009 | 1999 Volvo S80
Oct 07, 2009 | 2000 Volvo V70
Sep 14, 2009 | 2000 Volvo S80
Feb 13, 2009 | 2000 Volvo S80
31 people viewed this question
Usually answered in minutes!