How do i remove the right rear door panel on a 04 Chrysler Sebring

Use the right size screwdriver & do it slowly

you'll need some special tool as to not damage retainers for door panel,it's complicated to explain make sure you remove all screws ,some are hidden in door handle ,door release handle and under round circuler plugs ,take your time and be careful for wires and connectionc . can i ask YYYYYYYY WHATS WRONG ?

when ope door thir are plastic clips that you pop out with a clip remover and take phillips screw out at handle and remove panel

HI. Here is the complete line up of specs concerning your vehicles front and rear tires. You did not post the trim line of this car, so I posted all models and tire combination's specified by the manufacture.


2001 Chrysler Sebring Lim 2 Door Convertible Front and Rear Tires P205/60R16
2001 Chrysler Sebring LX 2 Door Convertible Front and Rear Tires P205/65R15
2001 Chrysler Sebring LX 2 Door Convertible Front and Rear Tires P205/60R16
2001 Chrysler Sebring LX 2 Door Coupe Front and Rear Tires P205/55R16
2001 Chrysler Sebring LX 4 Door Sedan Front and Rear Tires P205/65R15
2001 Chrysler Sebring LX 4 Door Sedan Front and Rear Tires P205/60R16
2001 Chrysler Sebring LXi 2 Door Convertible Front and Rear Tires P205/60R16
2001 Chrysler Sebring LXi 2 Door Coupe Front and Rear Tires P215/50R17
2001 Chrysler Sebring LXi 4 Door Sedan Front and Rear Tires P205/60R16

remove the hidden screws be hind mini covers, start from the bottom of panel with panel tool and pry the plastic retainers away from the door plate and remove the wire connectors form switches and replace the handle, reverse the order, GOOD LUCK, RDJRP

First disconnect your negative battery cable. Next locate and remove the screws that hold your interior door handles in place (they may be hidden by snap in, or snap on clips). Once you have removed the interior door handles, unplug the wire clips to the switches. Next you will need a small pry bar to remove the door panel itself. The door panel is held in place by snap in clips; try to get the pry bar as close to, or directly under the clips, to prevent them from tearing out of the door panel. Once you have removed the clips, pull the panel upward to remove it from the door. You will need to remove the plastic sheeting to gain access to the window regulator. You will need to remove the regulator and motor as a single unit, and once it's removed you can replace the motor.
Install everything in reverse.

it is part of the control arm simply unbolt the arm and remove it

had the same problem how that I fixed? had to buy the master window switch
2001 2004 Chrysler Sebring 4 Door Sedan Power Window Switch Front... Chrysler Sebring Power Window Switch AM Autoparts

The door panel is held on by plastic clips and 5 screws. 3 screws are on the bottom and 1 in the pull cup and 1 in the inner door handle.Then grab one of the corners and give a small tug, when you get some of the clips to pop out then proceed around the whole panel. To replace the panel take the clips out of the door with a fork and slide them back into the panel and then line it up on the door and use your hand like a hammer and bang the panel back on. Hope this helps