Where is the egr flow sensor on a 2005 dodge ram

Question 1

0helpful

1answer

2005 Dodge Ram 1500 4.7 Engine. Starts fine, Idles fine, but when engine shifts into high gear and RPM lowers engine runs really rough under load

Have you checked for a broken valve spring. Repaired a dodge engine with the same running issue as you have described and it was a broken intake valve spring.

Feb 22, 2015 • 2005 Dodge Ram 1500

0helpful

1answer

2004 dodge 1500 4 x 4 the engin mlight came on and the code is p0404. What does P0404 stand for?

SYMPTOM
P0404-EGR POSITION SENSOR PERFORMANCE

WHEN MONITORED
Engine running.

SET CONDITION
The EGR flow or valve movement is not what is expected.

POSSIBLE CAUSES
- Good trip equal to zero
- Excessive resistance in (F856) 5-volt supply
- (K34) EGR sensor signal circuit shorted to ground
- EGR assembly
- (K35) EGR solenoid control circuit
- Intermittent condition
- (K34) EGR sensor signal circuit open
- (K34) EGR sensor signal circuit shorted to ground
- (K900) sensor ground circuit open
- EGR assembly (ground)
- PCM
var classElements = new Array(); var node = document; var tag = 'a'; var els = node.getElementsByTagName(tag); var elsLen = els.length; var pattern = new RegExp("(^'\\s)specs_note(\\s'$)"); for (i = 0, j = 0; i

May 28, 2011 • 2004 Dodge Ram 1500

3helpful

2answers

What is the fix for (egr flow sensor a) on 2007 dodge hemi? This code came up when light came on.

It is probably the EGR valve itself. I would remove the valve and check the lines coming off of it to make sure it is not clogged. If that checks out ok then I would replace the EGR Valve and then clear the code with a scan tool.

Mar 25, 2011 • 2007 Dodge Ram 1500 Quad Cab Sport

1helpful

2answers

I have these codes coming up on my 2005 Dodge Ram. 5.7 liter motor: P0406 P2096 P0137 P2299 Thank you.

code #0406 = egr position sensor circuit high ( stuck egr valve or bad egr sensor most likely sensor )

code #2096 = downstream fuel trim system lean ( see next code )

code #0137 = O2 sensor bank 1 sensor 2 circuit low ( replace rear O2 sensor driver side )

code #2299 = brake peddle position/accelerator pedal position incompatible. ( hav you been power braking this truck? ) ( brake light was on wile accelerator was being pushed )

Mar 17, 2011 • 2005 Dodge Ram

0helpful

1answer

MY 2005 DODGE RAM 5.7 HEMI STALL RPM GO UP DOWN, 1 REPLACED EGR VAVLE, CRANKSHAFT SENSOR AND CAMSHAFT SENSOR.

Have you changed the fuel filter? If not' this may be your problem!

Mar 15, 2011 • 2005 Dodge Ram 1500

2helpful

1answer

2005 Dodge caravan 3.2 code 406? is this an

This code is for the EGR valve, "P0406 Exhaust Gas Recirculation Sensor A Circuit High", this doesn't necesarily mean you need to change your EGR valve but it's probable. Check with your dealer this just might still be covered.

Jun 06, 2010 • 2007 Dodge Ram Truck

0helpful

1answer

Dodge ram 1500 2005 code 0406

THIS CODE IS DEFINED AS EGR FLOW SENSOR "A" CIRCUIT HIGH INPUT. I HOPE THIS HELPS. THANKS FOR USING FIX-YA. PLEASE KEEP ME POSTED

Sep 05, 2009 • 2005 Dodge Ram 1500

0helpful

1answer

Where is the mass air flow sensor located on a 2005 dodge ram

ghoing found what you need:
http://74.125.155.132/search?q=cache:I8uuKUidsY8J:dodgeforum.com/forum/3rd-gen-ram/200009-air-sensor.html+2005+dodge+ram+mass+air+flow+sensor+location&cd=5&hl=en&ct=clnk&gl=us

Jun 13, 2009 • 1995 GMC Sierra C1500

0helpful

1answer

05 ram with hemi code p0406

Most of the times it is the EGR sensor that has gone bad. It is located in the back right side by the throttle body. You will see a hose that runs from the top of your EGR to the sensor. On your Dodge it is VERY eay to replace.

Jan 29, 2009 • 2005 Dodge Ram 1500

1helpful

1answer

P0406 Code on '05 Dodge Ram Hemi 5.7

this is a egr problem lack off flow

Jan 08, 2009 • 2005 Dodge Ram 1500

Question 2

Anonymous

Contributor 3 Answers
Posted on Nov 11, 2012

Anonymous

Contributor

Joined: Nov 03, 2012

Answers

3

Questions

3

Helped

2886

Points

17

Autozone stocks EGRs with lifetime warranty for 39.99. Just replaced mines on my 2005 ram 1500 quad with 5.7ltr Hemi. Also remove Pipe and clean out due to blockage. Also removed PCV Valve and replaced also.

Answer 2

Anonymous

Contributor 1 Answer
Posted on Jun 17, 2010

Anonymous

Contributor

Joined: Jun 17, 2010

Answers

1

Questions

0

Helped

2490

Points

1

Where is the egr flow sensor on a 2005 dodge ram 4.7liter engine

Answer 3

Anonymous

Contributor 1 Answer
Posted on Jun 10, 2009

Anonymous

Contributor

Joined: Jun 10, 2009

Answers

1

Questions

0

Helped

2490

Points

2

I just took mine to the auto part store to find out. From what they told me its the little box on top of the Hemi Engine cover. They said I have to go to the dealer to get the part though.

Answer 4 · 4/17/2010 12:00:00 AM

Anonymous

170 Answers
Posted on Apr 17, 2010

SOURCE: have a 2005 dodge ram with 5.7 hemi has an eng

Dodge/Chrysler EGR valves are known to be unreliable. The one on my wife's 05 Grand Caravan died in the 40k miles range.

They are not really serviceable. The usual fix is replacement. Part will be between $50 and $150 depending on where you get it. Installation most of the time is 2-4 bolts and the harness.

Don

tomas sidlauskas

95 Answers
Posted on Jun 13, 2009

SOURCE: where is the mass air flow sensor located on a

ghoing found what you need:
http://74.125.155.132/search?q=cache:I8uuKUidsY8J:dodgeforum.com/forum/3rd-gen-ram/200009-air-sensor.html+2005+dodge+ram+mass+air+flow+sensor+location&cd=5&hl=en&ct=clnk&gl=us

ZJ Limited

17989 Answers
Posted on Sep 07, 2009

SOURCE: egr valve location on dodge ram 2005 4.7

The EGR, or exhaust gas recirculation valve, takes inert exhaust gasses drawn from the exhaust system and reintroduces them into the combustion chamber through the intake manifold. This process lowers the peak combustion temperature and helps combat the formation of Nitrous Oxide (NOx) in the exhaust.

Separate the intake ducts from the air cleaner assembly by loosening the retaining clamps and pulling the ducts away from the housing.
Disconnect the vacuum line from the air cleaner assembly.
Remove the wing nut that secures the air cleaner housing lid to the base.
Remove both the air cleaner hosing lid and base.
Locate the EGR valve. Look at the front of intake manifold. The EGR valve will be bolted to the intake manifold just in front of the carburetor.

I hope help you with this. Good luck.

Answer 5 · 4/17/2010 12:00:00 AM

Anonymous

170 Answers
Posted on Apr 17, 2010

SOURCE: have a 2005 dodge ram with 5.7 hemi has an eng

Dodge/Chrysler EGR valves are known to be unreliable. The one on my wife's 05 Grand Caravan died in the 40k miles range.

They are not really serviceable. The usual fix is replacement. Part will be between $50 and $150 depending on where you get it. Installation most of the time is 2-4 bolts and the harness.

Don

Answer 6 · 6/13/2009 12:00:00 AM

tomas sidlauskas

95 Answers
Posted on Jun 13, 2009

SOURCE: where is the mass air flow sensor located on a

ghoing found what you need:
http://74.125.155.132/search?q=cache:I8uuKUidsY8J:dodgeforum.com/forum/3rd-gen-ram/200009-air-sensor.html+2005+dodge+ram+mass+air+flow+sensor+location&cd=5&hl=en&ct=clnk&gl=us

Answer 7 · 9/7/2009 12:00:00 AM

ZJ Limited

17989 Answers
Posted on Sep 07, 2009

SOURCE: egr valve location on dodge ram 2005 4.7

The EGR, or exhaust gas recirculation valve, takes inert exhaust gasses drawn from the exhaust system and reintroduces them into the combustion chamber through the intake manifold. This process lowers the peak combustion temperature and helps combat the formation of Nitrous Oxide (NOx) in the exhaust.

Separate the intake ducts from the air cleaner assembly by loosening the retaining clamps and pulling the ducts away from the housing.
Disconnect the vacuum line from the air cleaner assembly.
Remove the wing nut that secures the air cleaner housing lid to the base.
Remove both the air cleaner hosing lid and base.
Locate the EGR valve. Look at the front of intake manifold. The EGR valve will be bolted to the intake manifold just in front of the carburetor.

I hope help you with this. Good luck.

Related Topics:

Where is the egr flow sensor on a 2005 dodge ram

3 Answers

Anonymous

Anonymous

Anonymous

3 Related Answers

Anonymous

tomas sidlauskas

ZJ Limited

Add Your Answer

Attachments: Added items

Related Questions:

2005 Dodge Ram 1500 4.7 Engine. Starts fine, Idles fine, but when engine shifts into high gear and RPM lowers engine runs really rough under load

2004 dodge 1500 4 x 4 the engin mlight came on and the code is p0404. What does P0404 stand for?

What is the fix for (egr flow sensor a) on 2007 dodge hemi? This code came up when light came on.

I have these codes coming up on my 2005 Dodge Ram. 5.7 liter motor: P0406 P2096 P0137 P2299 Thank you.

MY 2005 DODGE RAM 5.7 HEMI STALL RPM GO UP DOWN, 1 REPLACED EGR VAVLE, CRANKSHAFT SENSOR AND CAMSHAFT SENSOR.

2005 Dodge caravan 3.2 code 406? is this an

Dodge ram 1500 2005 code 0406

Where is the mass air flow sensor located on a 2005 dodge ram

05 ram with hemi code p0406

P0406 Code on '05 Dodge Ram Hemi 5.7

Not finding what you are looking for?

2005 Ram 1500

2005 Dodge Ram 1500 4.7 Engine. Starts fine, Idles fine, but when engine shifts into high gear and RPM lowers engine runs really rough under load

Ask a Question

Check Out the Latest Top Trucks Report!

Top Dodge Experts

ZJ Limited

Thomas Perkins

Arnie Burke

Are you a Dodge Expert? Answer questions, earn points and help others

Manuals & User Guides

Related Topics:

Where is the egr flow sensor on a 2005 dodge ram

3 Answers

Anonymous

Anonymous

Anonymous

3 Related Answers

Anonymous

tomas sidlauskas

ZJ Limited

Add Your Answer

Attachments: Added items

Related Questions:

2005 Dodge Ram 1500 4.7 Engine. Starts fine, Idles fine, but when engine shifts into high gear and RPM lowers engine runs really rough under load

2004 dodge 1500 4 x 4 the engin mlight came on and the code is p0404. What does P0404 stand for?

What is the fix for (egr flow sensor a) on 2007 dodge hemi? This code came up when light came on.

I have these codes coming up on my 2005 Dodge Ram. 5.7 liter motor: P0406 P2096 P0137 P2299 Thank you.

MY 2005 DODGE RAM 5.7 HEMI STALL RPM GO UP DOWN, 1 REPLACED EGR VAVLE, CRANKSHAFT SENSOR AND CAMSHAFT SENSOR.

2005 Dodge caravan 3.2 code 406? is this an

Dodge ram 1500 2005 code 0406

Where is the mass air flow sensor located on a 2005 dodge ram

05 ram with hemi code p0406

P0406 Code on '05 Dodge Ram Hemi 5.7

Not finding what you are looking for?

2005 Ram 1500

2005 Dodge Ram 1500 4.7 Engine. Starts fine, Idles fine, but when engine shifts into high gear and RPM lowers engine runs really rough under load

Related Topics

Ask a Question

Popular Questions

Vacuum hose diagram.dodge ram,1500,4x4,5.2l

Electronic Throttle Control light

Need stereo wiring diagram

2005 dodge ram 5.7 hemi

Brake line diagram for

Check Out the Latest Top Trucks Report!

Top Dodge Experts

ZJ Limited

Thomas Perkins

Arnie Burke

Are you a Dodge Expert? Answer questions, earn points and help others

Manuals & User Guides