1996 Oldsmobile 98 regency elite airbag problems

You might benefit from the 96 Regency Elite factory service manual purportedly available by a download for $22, if scrolling through pages or using CTRL F to hunt through a PDF is something you are comfortable with. I have no idea if it tells you to check for rust in the fuel tank. https://www.tradebit.com/filedetail.php/281883502-1996-oldsmobile-regency-service-and-repair-manual

The Haynes group is of course more familiar and there seems an aside mention of the 96 being covered in spite of the title. https://haynes.com/en-us/oldsmobile/regency/1997-1998

Regarding videos, I encounter such for the Olds Bravada and the Olds Aurora, both 96 models: https://www.youtube.com/watch?v=dO3QkeMTwP0
This experts advice bears looking at: https://www.justanswer.com/car/1wohy-replace-fuel-pump-remove-gas-tank-1996.html

General advice about replacing Olds fuel pump: https://www.yourmechanic.com/estimates/oldsmobile/regency/fuel-pump-replacement

https://www.walmart.com/ip/Fuel-Pump-Compatible-with-1995-1996-Oldsmobile-98-Regency-Elite-FWD-Sedan-4-Door-3-8L-V6-Naturally-Aspirated-OHV-GAS-1994/1595603100

Question edited for clarity.

Check out the previous Fixya question with answer, and the other information in the link. It is a known issue.

https://www.google.com/search?q=1991+Oldsmobile+98+Regency+Elite.+How+do+I+change+the+HVAC+control+module

..

Possible faulty crank sensor or idle speed controller, fuel pump relay, or ignition module. Get a data scan and see what's sensor might out of range or defective. Check for clogged fuel filter also.

Where is the starter fues

Maybe it helps

https://www.autogenius.info/category/oldsmobile/oldsmobile-regency/

I have a 1992 /98 0lds the air condition will not work unless I take the ground wire lose then it kicks in but it show that makes car is over heating when it is not what sencer is doing this please help [email protected] it is hot in texas

Well, for starters, your problem got posted under 1985 Oldsmobile 98 - then you said it was a 95 Oldsmobile 98 Regency Elite (HUGE difference between 85 and 95)...then it would be REALLY nice to know which engine we are talking about.

I'll just go with what you said last: 1995 Oldsmobile Regency Elite (Two engine possibilities)

If you have the 3.8L Supercharged engine (VIN CODE "1") it is on the left side of the engine near the oil filter.

If you have the non-supercharged 3.8L (VIN CODE "K") there are TWO of them. One is near the oil filter and the other one is in about the same location on the other side of the engine block.

Please also note that MOST fault codes for knock sensors are not caused by the knock sensors themselves. (they do fail, but it is very rare.) Usually there is either a wiring problem to the knock sensor, or the engine has internal problems causing a "knocking" or "ticking" noise which causes the engine computer to "think" that there is a problem with pre-detonation causing an "ignition ping". The code sets when the computer has retarded the ignition timing as far as it can and the "knock" or "ping" does not go away....usually it doesn't go away because it is not caused by ignition timing. The knock sensor is just doing its job and reporting the knock. It does not know the difference between a knock caused by ignition and a knock caused by internal engine problems.

through the trunk.

there is a small set screw in the base of the mirror you will need to loosen this and then slide the metal plate out.

there are alot of variables for this. the only way to get the complete list and to find out what has already been performed is to contact your local gm dealer with your VIN number. good luck!