SOURCE: changing the tail light assembly on a 2004 hyundai santa fe
lift the tailgate, and you should see 2 screws on the side of the lamp assembly. remove the screws, and remove the lamp assembly by sliding it sideways away from the vehicle. you will be able to access the bulbs & sockets once the taillamp has been released.
SOURCE: ''check engine light'' illuminated, 1004 Hyundai, Santa Fe
If you live in the US, take it to qany Auto Zone store and thy will read the codes off for you, I would suspect any right thinking competitor would do the same, check if you don't have one near by.
Hope this is of some help.
Ed
SOURCE: Hyundai Santa Fe 6 cyl and spark plug robbery?
On the 2.7 V6, you have to remove the surge tank from the intake manifold to gain access to the ignition wires and the spark plugs. 2hr job.
SOURCE: Change serpentine belt 2004 Hyundai Santa Fe
it uses a spring loaded tensioner.use a breaker bar to rotate the tension and it should just come off.if u need a pic or anything else to do it let me know,
SOURCE: how to replace a valve cover gasket 2003 hyundai santa fe
Just take a picture of it with digital camera or phone. And start removing wires and hoses until they are all out of way of cover. Then remove the bolts all way around cover and pull straight up and it will come right off. If not use a flat head screw driver to prise it off. Clean old gasket off of valvecover and engine. then put it bak together. Tighten bolts slowly, start with ones in center ov it and work your way out. Just finger tight. Then snug, then torque em down. Not too tight as if tostrip the bolt or break it off. Cause it be very expensive. also write down everywhere each wire go's unless you can remember
240 views
Usually answered in minutes!
×