Palio brake light replacement - 2006 Fiat X1/9

Question edited for clarity.
Question moved to model category.

This is a very obscure make and model in North America, but this link might work better for you.

https://www.google.com/search?q=Fiat+Palio+1.6+replace+radiator

Generic video.

Hello. The brake master cylinder must be removed first then the brake booster second. Good luck and keep me informed; if you want to.

the 2008 Fiat Palio 1.2 has a self adjusting
hydrualic clutch pedal system

the brake resiviour fluid has to be full
have to bleed the air out of the system at the slave cylinder

if there is a leak or by passed the internals of master or slave
those parts need to be replaced

Just a sugestion (re 1.6 bravo) over fueled and washed cylinders to give low compression if moderate milelage on clock and engine spinning freely.

run fault codes and check immobiliser operation

plug isn't firing-change coil pack out and try again- Denny

Flush out coolent system, make sure your cooling fan for the engine is not faulty, replace waterpump and thermostat, fill with coolent, and im 99% sure you will not overheat as long as your coolent is topped off. Guarenteed!

Check fuel pressure maybe fuel pump

NEED TO CHECK WITH A MACANICAL GAUGE AND CHECK OIL SENSOR

THERE IS A NIPPLE ON SLAVE CYL FILL WITH BRAKE FLUID PRESS PEDAL DOWN OPEN NIPPLE KEEP PEDAL DOWN AND CLOSE NIPPLE REPEAT UN TILL NO AIR COMES OUT