The only realistic way the gauges can come back on is if there is a problem with your ignition switch - it is not staying off in the off position. The switch is located at the bottom of the steering column and may have come loose, may be misaligned or may be faulty.
SOURCE: Windshield wipers will not go back down after shut off.
THE PROBLEM HERE IS WHAT IS CALLED THE WINDSHIELD WIPER MOTOR PARK CIRCUIT, YOU MUST REPLACE THE WIPER MOTOR TO FIX IT. I DON'T KNOW WHY IT GOT BURNED OUT, WHERE THE WIPERS ON WHEN THE BATTERY WAS DRAINED?
SOURCE: Replace window motor assembly 2001 Chev 1500 extended cab truck
you can order it at some dealer ships . it cost about 150.00 dollars or more.
SOURCE: 97 dodge dakoata main fuse keeps blowing 140 amp fuse
Regulator in alternator obviously faulty, have it bench tested & fixed or replace alternator, and cure your problem.
SOURCE: Battery dies after 2 days of non-use. Checked
it would take about 350 hours to kill your battery at 200 ma leakage .. between the computer, radio and anything else that has "keep alive" conditions .. i would think 200ma is maybe on the high side of normal .. to kill the battery in 2 days would require a continuous drain of more than 1.5 amps .. that would be about what the trunk light or under hood light would draw .. make sure those are going off .... alternator diodes can have leakage thats very high .. of course if you are measuring the leakage current right at the battery connector then all leakage sources should be included in the reading .. if its only 200ma then you might have a bad battery (low on water or sulfated) .. Pb acid batteries are easily ruined by leaving them discharged for a while .. and the maintainence free types can only handle a few deep discharges .. .
SOURCE: 2001 chevy silverado 4.8 gas gauge not working properly
Fairly common problem with GM vehicles. The sending unit in your tank has a small circuit board that an arm is attached to which moves up and down according to your fuel level. This circuit board and arm are not making good contact. Unfortunately the only good solution is to replace this part.
Testimonial: "thought probably that was it but better off replacing whole unit .i was for for gauge proplem thanks. "
138 views
Usually answered in minutes!
×