Broken moonroof I cannot close the moonroof.  The switch is nonresponsive.  Is there a way to manually close?

To reset the moonroof, flip the ignition switch to the "ON" position. Then, press and hold your moonroof's button towards the full-tilt position. Repeat that step a second time once the moonroof is tilted upwards. After getting the moonroof to tilt upwards a second time, hold the button for an additional four seconds.
May 9, 2018

My Moonroof Won't Close or Open - What to Do

it sounds like something that is broken inside ,u might need a new moon roof track complete unit

You will need to remove the entire assembly and find out what is broken, it is real pain in the rear and is very time consuming, about 8 hours hard work, the headliner must come out and that means all the interior trim be removed.

expose the mechanism
decouple the drive motor and move it closed.
did you read the operator guide.
or the FSM, the FSM covers this.
and both are on line.

It may be a faulty moonroof switch or an electrical short.

I had that same problem the other night. Started the car the next morning and pushed the switch and it closed, but it will no longer open or tilt.

On EX and EX-V6 models:
The moonroof has two positions: it can be tilted up in the back for ventilation, or it can be slid back into the roof. Use the switch under the left dashboard vent to operate the moonroof. The ignition switch must be ON (II).
To tilt up the back of the moonroof, press and hold the center button. To close the moonroof, press and hold the top of the switch To open (slide back) the moonroof, press and hold the bottom of the switch. Release the switch when the moonroof gets to the desired position. Make sure everyone's hands are away from the moonroof before opening or closing it.
The moonroof has a key-off delay. You can still open and close the moonroof for up to ten minutes after you turn off the ignition. The key-off delay cancels as soon as you open either door. You must then turn the ignition ON (II) for the moonroof to operate.
Hope this helps.

I don't know if this will work, but you can try it. If you use the manual method for closing the moonroof, or opening it, it MIGHT take the shade along with it. The following is the procedure, which you may already know.
The moonroof can be closed manually, if the control switch will not close it.
1. Remove the round plug near the rear center of the headliner.
2. Insert the moonroof wrench (from the tool kit, should be in the trunk) into the socket.
3.Turn the wrench until the moonroof seats in the closed position.
4. Replace the plug.
As I say, this MIGHT work. Hope it helps.

you are having a problem with either your power switch which opens and closes the moonroof. or either you may in fact have a motor problem with moonroof. check to see if you may have an electrical short in your system. also you also may have something wrong with your moonroof sliding armature.