SOURCE: 4jx1 camshaft marks on isuzu trooper 2001 3,0 dohc
the timming gear that the belt runs on has a mark (V cut in gear) to rear cover at about 12 o clock and crank pulley has timming mark for top dead centre, both cams have cut outs in rear that a special tool (camshaft stopper 5-8840-2592-0) locks into to hold cams in correct position, but can do without this, if the cam belt gear is off, the keyway should be at 12 o clock. the marks in the camshaft gears (dots) is for assembly of sissor gears to solid gears on camshafts that run together and they should match up only if you had this appart.
no.1 is timming mark
this is the locking plate tool
SOURCE: where is the location of the egr valve on a 2001
on petrol V6 engine its right rear side of inlet manifold(left side when looking into engine bay) see pics. below
diesel its on inlet manifold left side middle section of manifold
SOURCE: How do I change the transmission filter in a 2001
Jack car up, remove drain plug and drain fluid, once it has stopped dripping, remove all the bolts around tranny pan, lower tranny pan, remove the bolt or 2 bolts that hold in the filter. Replace with new filter and new tranny pan gasket and reinstall the bolts.
Then add new fluid, with foot on the brake and vehicle running, shift to each gear for 5 seconds, repeat three times and this will bleed any air out of the system and you will be good to go.
176 views
Usually answered in minutes!
×