SOURCE: Erroe codes on Dodge Ram 3500 Diesel, dually
The 1682 code is - Charging System Voltage Too Low
The 1693 code is - DTC Detected In ECM Or PCM
The 0523 code is - Engine Oil Pressure Sensor/Switch High Voltage
SOURCE: To replace the rear fender on my 2005 Dually, how
they bolt on through the bed which is a hard one to change for most
SOURCE: i turned the key to my 2001 dodge ram 3500 and it
A code P0500 may mean that one or more of the following has happened:
1.The Vehicle Speed Sensor (VSS) is not reading (functioning) properly
2.There is a broken/frayed wire leading to the vehicle speed sensor
3.The vehicle's PCM is not correctly configured for the actual tire size on the vehicle
The simplest thing to do is to reset the code and see if it comes back. Next, check all wiring and connectors that lead to the speed sensor. The location of the sensor depends on your vehicle. The sensor could be on the rear axle, transmission, or perhaps the wheel hub (brake) assembly. If the wiring and connectors are OK, then check the voltage at the speed sensor.
P1693 (M) DTC Detected in PCM/ECM or DTC
Detected in ECM
A 9Companion DTC9 was set in both the ECM and PCM which is related to the above DTC code.
SOURCE: How to change transmission fluid and filter. 2004 dodge ram 3500
remove trans oil pan. there you will also see your trans filter,
SOURCE: how to remove the rear brake rotor on a 2006 dodge
Single rear wheel - Remove both caliper bolts.. remove caliper and pads.. remove rotor.. they are usually rusted on pretty good.
Rear Dually- the rear rotors are mounted with the hub assembly.. you must first remove the rear axles.. then remove nut holding load on bearings.. then the rotor and hub assembly will come off as one unit.. removed rotor from hub..
76 views
Usually answered in minutes!
×