Remote key fob stopped working not battery

Follow the instructions on http://www.bluejag.co.uk I would normally cut and paste the details but you can't do this now, so sorry.
Don't go to Jaguar dealership unless you have cash to waste, and the turn 8 times solution may well work but is incorrect. There are other things that you need to be aware of (all explained on the website)

You can purchase pre-programmed keys only from Jaguar. However you can purchase keys on the internet and match them to your car as follows:-

Jaguar X-Type Programming (Pairing) a Remote KeyFob X-Type 2.0, 2.5 and 3.0L



Programming or pairing a new remote Keyfob for the X Type is a very simple job that will cost a substantial amount if it is done by Jaguar. It's annoying but this may need to be done if your Keyfob battery has been allowed to go flat, or the car battery has been removed for any length of time.
Follow these steps exactly and you should have no problems, pairing old or replacement Keyfobs for your car.

1.)I would recommended that you ensure all key fobs are fitted with new batteries. ( Click here to see battery replacement guide).
2.)Get in the car and close the drivers side door.
3.)Put the key into the ignition and turn to position I.
4.)Wait 5 seconds
5.)Turn the key quickly to position II then back to I four times.
6.)You should hear a single chime.
7.)Remove the Key
8.)For each Keyfob in rapid succesion. Press any single button on the keyfob you wish to pair, you should hear a chime as each Keyfob is paired with the security system. After the chime do the next Keyfob.
9.)Check operation of each Keyfob.
Further info can be found on http://www.bluejag.co.uk

Full details can be found at http//www.bluejag.co.uk Jaguar X-Type Programming (Pairing) a Remote KeyFob X-Type 2.0, 2.5 and 3.0L


Programming or pairing a new remote Keyfob for the X Type is a very simple job that will cost a substantial amount if it is done by Jaguar. It's annoying but this may need to be done if your Keyfob battery has been allowed to go flat, or the car battery has been removed for any length of time.
Follow these steps exactly and you should have no problems, pairing old or replacement Keyfobs for your car.

1.)I would recommended that you ensure all key fobs are fitted with new batteries. ( Click here to see battery replacement guide).
2.)Get in the car and close the drivers side door.
3.)Put the key into the ignition and turn to position I.
4.)Wait 5 seconds
5.)Turn the key quickly to position II then back to I four times.
6.)You should hear a single chime.
7.)Remove the Key
8.)For each Keyfob in rapid succesion. Press any single button on the keyfob you wish to pair, you should hear a chime as each Keyfob is paired with the security system. After the chime do the next Keyfob.
9.)Check operation of each Keyfob.

yes it has a battery ,but not sure if just renewing the battery will make it work again,i changed both my batteries on my remotes (spare) without any problem.for
my sovereign

More infomation can be found at http://www.bluejag.co.uk Jaguar X-Type Programming (Pairing) a Remote KeyFob X-Type 2.0, 2.5 and 3.0L


Programming or pairing a new remote Keyfob for the X Type is a very simple job that will cost a substantial amount if it is done by Jaguar. It's annoying but this may need to be done if your Keyfob battery has been allowed to go flat, or the car battery has been removed for any length of time.
Follow these steps exactly and you should have no problems, pairing old or replacement Keyfobs for your car.

1.)I would recommended that you ensure all key fobs are fitted with new batteries. ( Click here to see battery replacement guide).
2.)Get in the car and close the drivers side door.
3.)Put the key into the ignition and turn to position I.
4.)Wait 5 seconds
5.)Turn the key quickly to position II then back to I four times.
6.)You should hear a single chime.
7.)Remove the Key
8.)For each Keyfob in rapid succesion. Press any single button on the keyfob you wish to pair, you should hear a chime as each Keyfob is paired with the security system. After the chime do the next Keyfob.
9.)Check operation of each Keyfob.

Your key fob needs reprogramming, and yes the alarm will go off when you open the door, but you have enough time to put the key in the ignition which will prevent the alarm sounding. Car is usable until you get the fob sorted by locking and unlocking using the key.

hi,when you remove the key from the ignition,does the little flap in the barrell flip down?.if not the key fob wont work.it thinks the key is still in the barrell.after a tiny bit of wd40 on the key it was ok.it pickled me head for ages.maybe its that. paul

could be static build up in remote dealer has foam pads that can help eliminate this

Seperate key fobs only can be programmed in the following way.

Turn ignition on/off 8 x times (allow all functions to stabilise) after the 9th on - press a button on both remote fobs. then turn ign. off. use good remote to lock and then try new remote to unlock/lock. sometimes it works first time - sometimes you have to repeat actions. good luck.

Your key FOB is easily programmed by yourself without the need of computer, here is how: Push and hold the trip computer button on the left stalk, while holding the button turn the ignition ON and OFF several times untill you hear a confirmation tone from the glovebox area, when the tone is heard, release the button and remove the key from the ignition, immediately after push any button on the Key FOB and you'll hear another tone that confirms the programming.