Can vehicle engine mounts cause no-start on a 2000 cadillac dts?
ignition switch been replaced 2 times and maybe short near but cant find. sometimes i tap near ignition switch and all display is ''ok''
Yes that is possible, excessive engine movement from bad/broken mounts put added pulling load on the wiring harness to the engine, it can pull connectors loose and break wiring inside of its insulator, bend a piece of wire over and over and it breaks, the same applies here.
Have 2006 dts at times the car startes fine then at other times it will not start all dash lights go out and makes a sound like q hammer hits steel a loud ping repeat turning it on after 5 or 6 tries it starts now the car runs great just this problem we put ground cable on it no change. just where is the starter relay located??????? HELP!!! P/S NO CODES CAME UP ????
298 views
Usually answered in minutes!
Engine will not start/pass key fault display on the dash. Does the vehicle ignition need reseting? If so, how to reset the ignition?
×