What is the p0455
Testimonial: "Po455 don't know Wat this is?"
SONATA(NF) >2006 > G 3.3 DOHC > Engine > Engine Control > P0455 Evaporative Emission System-Leak detected(Large leak)
If the fuel cap is missing or was not tightened properly, could cause this code p0455
There's also a pressure sensor in the fuel tank which is used to monitor pressure in the fuel tank when the engine computer performs periodic EVAP system checks. If this sensor is not working properly, it could also cause P0455 to set.
Another possible cause of p0455 is the PCSV (Purge Control Solenoid Valve). If it's stuck closed, the ECM will set P0455
×
SOURCE: clutch kit mazda drifter 2.5 diesel turbo d/cab 4 x 4 model 2002
http://www.clutchcityonline.com/mazda_b2500.htm
There you go, just click on your year and the clutch kit. You can always call your local auto store and ask them to price it for you.
Thanks,
Lee
SOURCE: Clutch replacement details for 1996 legacy GTB
Trust me it is quite an excercise and not worth doing yourself. With the proper tools, a hoist and a my mate who is a Guru Subaru Mech it took 4 hours. Without having done it before and without the Hoist ( which is wha I was going to do initially ) I'd say you wouldn't get much change out of 8 - 12 hours.
SOURCE: how easy is it to replace a noisy clutch thrust
The thrust bearing is normally a part of a new clutch kit.Comprises pressure plate, clutch plate and thrust bearing.You will need to remove the gear box to change the bearing.The bearing basically slides onto the gearbox shaft. Recommend changing all three rather than just the beaing.You may want to get quotes from garages as dealers are expensive.
SOURCE: transmision .
I do believe that is the Mitsubishi, I agree that the Library would be your best bet. the haynes manual I am looking at doesn't go into detail however. You may need to get a Bentley manual.
The clutch, now there's a good question. the real question is.... Do you want to pull it again after all this work... Ya didn't think so.. the parts rill run around 220 for pressure plate, and disc. Replace the slave cylinder also as they love to fail..
I can add this hint. If you are on the ground doing this, to replace the tranny use two tie down straps across the frame and under the tranny lift with a jack but support with the straps. this makes lining it up a breeze and if a 4WD you can even attach the transfer case and rear mount.. made it super easy for me... I did it by myself in under an hour..but I was stupid first I replace the slave cylinder then a year later the pressure plate. I then replaced the slave cylinder a second time... Hey 40 bucks was cheap...
SOURCE: 5-speed transmission making noise in 3rd and 5th gear
are u sure the alignment (side to side, up and down) of the trans on the bell housingis not out of spec, that will burn the bearings out very quickly.
80 views
Usually answered in minutes!
Yamaha trail bike
×