All of a sudden my keyless entry key won't open any doors/trunk. I had to open the car with the mechanical key attached on the side. Alarm came on and my keyless entry key won't reset the alarm even if i insert the key to the ignition. Now the alrm is still activated. Installed new battery on the key. Car battery is also ok. Can't turn the ignition either plus the alarm is still activated. Unfortunately i only have 1 key
SOURCE: reset alarm on 2000 Mercedes C230
Disconnect the battery lead at the starter motor.Leave off for a few hours then reconnect it.It should reset it for you.
SOME OF THE REMOTES REQUIRE THAT THE KEY BE IN THE IGNITION, IN THE ON POSITION. TAKE THE BATTERY OUT AND WAIT 10 MINUTES. THEN PUT THE KEY IN THE IGNITION AND INSTALL THE BATTERY WHILE THE KEY IS TURNED TO THE ON POSITION. HOPE THIS HELPS YOU. PLEASE KEEP ME POSTED. THANKS FOR AN HONEST RATING AND FOR USING FIX-YA. GOOD LUCK
SOURCE: trunk release for 2000 mercedes s 430 not working properly
Trunk can be lock separate from the doors valet try unlocking the trunk with the key lock it with the door.Read the owner manual it will tell you about valet parking.
SOURCE: mercedes c200 sport ignition key will not turn in
The EIS (Electronic Ignition Switch) is malfunctioning. You will have to replace the EIS and take the car to a dealer to reprogram the keys.
SOURCE: MERCEDES S320 model 1999, key locked in the Trunk.
Isn't there botton somewere on the door or left lower conner of dashboard to open trank remotely?
-
Press the UNLOCK button on the keyless entry transmitter.
-
Insert a valid key into the ignition and start the vehicle.
?€¢
To disarm the CTD system in the armed mode:
-
Press the UNLOCK button on the keyless entry transmitter.
-
Insert a valid key into the ignition and start the vehicle.
?€¢
To disarm the CTD system when activated, alarming mode.
-
Press the UNLOCK button on the keyless entry transmitter.
-
Insert a valid key into the ignition and start the vehicle.
681 views
Usually answered in minutes!
×