I need to replace a front side light on my vitara, but i cant find where the bulb holder goes in headlight
SOURCE: Suzuki swift Headlight problem
Have you checked to see if this is a wiring problem or maybe a relay problem?
Recently my lights would work on side lights and not anything else and this was down to dodgy wiring and needed a new relay unit.
SOURCE: how do you remove front grill on Susuki grand vitara
Remove the clips that secure the top of the radiator grille. Pry up the center piece and pull up the clip to remove it. There are 5 screws on the bottom of the grille piece that you have to take out. BE VERY CAREFUL with the grille when pulling it out as it idoesn't take alot of force to break it. Next undo the screws that secure the headlight housing (3 total), there is also something called a guide pin on the housing. Detach the connector from the bracket by squeezing the lock tip with pliers. That should give you complete access to the lamps inside the housing.
SOURCE: how do I remove and replace the front axle?
you first need to remove the big nut that is holding the wheel on the side that you are trying to replace first you must buy the right sized socket thet will fit the nut the while the vehicle is still on the ground take the hub cap off and the cater pin out and then put the socket on the nut using a halt inch tourge ratchet loosen and remove the nut then jack your vehicle up and remove the wheel and the bolts that are holdung the hub and then with a pickle fork that is the tool used for removing tie rod ends that is connected to your stirring and then after that remove your axle and then reverse the procces to put ti back together.
SOURCE: can I replace a suzuki vitara 1998 v6 engine with
My Suzuki Escudo loses power when you accelerate. has just had new fuel filter and leads fitted, but still no difference, Any suggetsions
Identify the blown bulb. Note that if a headlight bulb has blown, the dip beam is on the outside and the high beam is on the inside. Turn off the ignition switch and light switches.
Open the hood and replace any blown headlight bulbs. Press the plastic spring clips and remove the bulb holder from the assembly. Pull the bulb out of the bulb holder and replace it with a new bulb. It only fits one way. Be sure not to touch the bulb's glass. Replace any parking lights at the same time, they are in the headlamp unit too.
114 views
Usually answered in minutes!
×