I replaced computer in my 99 Honda accord from one I got from junk yard and it don't have a key recognition .the car has power to fuel pump and to spark plugs . the fuel pump is working . the only thing that I don't have is injector signal .and I have to get car running to take and have computer reprocamed
SOURCE: 89 s10 2.5 has fuel and fire injector has power but no pulse
injector pulse is just controlled by the ecm or computer as some would say,u said u replaced wires? did u have a fire or melt wires? ecm is known to go bad on these,had a few of these trucks back in the day.
SOURCE: 82 corvette crossfire injection, engine
Please go to the crossfire injection forum to get some straight answers to the 82 corvette CFI system and how to troubleshoot it properly. There's a lot of misinformation given here, so much so, I don't know where to begin.
One thing is, the 82 corvette CFI does NOT have a MassAir Flow sensor system, it uses MAP and O2 mostly. The CTS sends a signal to the ECM telling it what the temp of the motor is and in turn the ECM controls the amount of fuel being dumped. On the older (orignal) CTS sensors, they have one wire and takes its ground from the threads. If any coorosion takes place, usually the CTS will report a cold engine and request lots of fuel.
To repair this issue, install one of the newer style CTS sensors that have two wires, one for signal and the other is ground.
Fuel pressure and vacuum leaks on any CFI motor play key roles. Set the FP to 14-15psi measured inbetween the TBs. The regulator is located on the rear TB and must be slightly moded to make it adjustable and can be done in a few minutes.
SOURCE: 1999 chevy blazer wont start
THE FUEL PUMP IS BAD.
if your losing fuel pressure after the pump runs the drain back valve in the pump has failed.
and i doubt that you are seeing enough fuel pressure to run a vortec engine.
low fuel pressure equals a non running vortec
SOURCE: 89 camaro v8 5.7L, tune port fuel--Not getting power to injectors
sounds like the injector got stuck close because of sitting so long....take em out and cleasn them up real good an try that it should work make ensure the wires have a good solid connection and no bent pins.
SOURCE: 1992 corvette no comunication between modules
I had a similar problem on my 92 LT1 and it turned out to be the opti-spark was bad not signaling the injectors to pulse, if your bypassing the VAT to turn it over then the injectors should fire as well, on the 92 the crank sensor is built into the opti-spark distributor as well, if it turns out to be the opti-spark spring for the MSD sealed and vacuum vented cap or you'll just be replacing the thing every six months, you can test the opti up were it runs into the coil, I dont remeber the exact proceedor but it is on line,
56 views
Usually answered in minutes!
×