Open the door that is stuck 1990 Celica

SOURCE: outside sliding door handle?

Yes. It is a difficult job, but not impossible. The hardest part is actually removing the interior door handle. Here are the steps.

1. remove the interior door handle by pressing the door panel in and prying out the C-ring retainer clip
2. remove the lock slide switch bezel with 1 screw, then insert a blade on the bottom left of the slider between the slider and bezel, and release the clip, the slide the bezel toward the rear of the vehicle and pull out
3. carefully unclip the door panel around the lower edge and sides and lift the door panel UP and off
4. remove the interior lock slide switch with 2 screws
5. pull back the plastic vapor shield part way to expose the mechanism
6. there is a cable that runs from the mechanism to the exterior handle, unclip it from the door frame
7. there is a rod that drops down from the door handle to the mechanism, release the rod from the plastic clip
8. locate a large (likely black phillips) screw next to the door handle on the EDGE of the door, remove it
9. locate a 10mm screw on the inside behind the door handle, remove it
10. locate the final 10mm screw behind the handle through an access hole, remove it (careful not to let it fall inside the door)
11. the door handle will push out through the door part way- there is another C-clip securing the lock cylinder that will need to be removed, and the lock cylinder can be pushed into the door cavity
12. pull the door handle through the outside of the door skin- the door handle assembly is still attached inside the door by the latch cable- the cable can be easily removed from the handle assembly to remove it completely
13. you will likely find that the end of the door handle itself is broken off- don’t buy a new handle! Email me and I will show you my free and possibly better solution that will likely last the life of the vehicle dbonnell1972 at yahoo dot com

SOURCE: 2002 Toyota Celica GTS

Thanks you for asking for my assistance.
Let me clarify, the entire handle assembly is moving on the outside of the door when you open it; it is real loose? If so, there are two 10 millimeter bolts that hold the handle in place. Yes, you do have to pull off the door panel to access the handle bolts. I can give you the panel removal proceedure if you need it.

SOURCE: 2005 sequoia rear latch

purchase a paint roller tool where the roller part is only about 4" or so long. tear off the soft roller. bend the bar another 45 degrees so the angle from the handle to the part that had the roller on it is about 135 degrees. make sure all 4 doors are unlocked.
get on your knees and look on the right side of the handle where it goes into the door. you will see where you will insert the paint roller. now stand up. facing the door hold the paint rollerhandle in your right hand so it is sticking straight out from the door horizontally . insert the business end into that hole vertically. you will then feel for the "pad" which you are going to depress inside the door. when you feel it, turn the handle you are holding to the right slightly because you are now gong to push on that pad towards the front of the car. in order to do that, you need more clearance and that is why you are moving the handle. use your left hand to stablize your tool at the bend. at the same time put some of your weight on the door as if you were pushing it closed. you will hear it unlatch. lift the door as if the door handle worked. voila. the door is open.

SOURCE: 99 toyota corrolla hood latch is broken. Can't

There is a rachet right below the hood that you can reach from radiator grill.
Take a long thin screw driver, reach it and turn that rachet.
You will hear the "click" sound and the hood will pop open.

SOURCE: 95' Camry drivers door lock is Jammed. Door wont open at all.

You tell me. Is jammed?