Can to a stop and pushed in clutch bt could not get back into gear i changed the master and slave cylinder but still will not go into any gear
First thing to do is double check the work/parts since you replaced both Cyl's. Have someone push on the clutch pedal and another look at the trans. Is it moving the clutch fork in and out when pushed.
If yes then that is not the problem.
If no then rebleed them and replace again if the bleeding doe snot fix.
If they are ok then the next problem would be a pressure plate. If it is broken then the clutch fork/release bearing can;t do its job. So buy a clutch kit (bearing, plate, and disc) and install that.
Have someone push the clutch pedal while you watch the slave cylinder to see if it is pushing the clutch fork far enough. If it is not, then you will need to bleed the system again. Only use Dot 3 non ABS brake fluid (don't mix em). If it is moving it, then there is damage inside the bell housing.
Is it grinding when you try to put in gear or is it just not going at all.detents or syncros
279 views
Usually answered in minutes!
×