95 hundai accent wont start

If your grounds are good and clean, I would test the switch itself.

how do you know the battery is good? may not have enough power under load like starting - you have it load tested.
make sure your battery connections are clean and tight

hi

just clean the spark p[lug or wash the filter also

Check the battery like this:
Turn on the headlights, then try to start the car.
If the headlights do not dim or go out, then the battery is likely ok.
Check that the battery cable plus post, goes to the starter, Minus post to a good ground, like the engine.
If wiring is ok, then look at the starter solenoid for a good connection.
Problem is most likely the Solenoid or starting relay, whichever the car uses.
Hope this helps.

I'm not a car mechanic, but, it sounds like you might want to check the fuse to the ignition switch, and, if that fails, it might be a problem with the Start Safety Switch on the transmission. Good luck.

Check your grounds. You can use a jumper wire from the battery ground post to the ground circuit of each component. For testing.

Have it towed to a car alarm specialist that is familar with Chrysler products. With a little luck they can fix it.. To reset alarm
(if it will work}, try locking drivers door and unlock it with the remote from outside.

The 5 second thing does not sound good.. Usually this locks your ECM out so it will never start. Thinks someone is trying to steal it.

if you have a test light check for power TO the fuse.there should be power at the fuse at all times.to do this clamp test light to a good ground under the dash and touch the top of the fuse on ether side, power should be at both sides.if you got power, remove the headlight switch,test for power at ether the red,yellow or brown wire,if you have power here,turn on head lights unplug each head light test for power at each socket,test the ground at each socket to do this,clamp your test light to the POSITIVE side of the battery touch the other end to the ground side of the light socket if the test light does NOT light,fix the ground wires this procedure is the quickest so do this first than try the steps above

the grounds may be bad they are behind headlamps but more than likely it is the switch

test you battery at parts store they can load test it for you headlites int lights are nominal draw. wipers blowers pull a little more current. but have it tested under load which duplicate the significant draw of a starter.

shack