Sensor light is ''on'' on the dash board. Dealer has said that the Control Module is faulty and that they can replace it for over £400 ($700). I know that I can find the module for a fraction of the price else where. What I need to know is... where on the car (NISSAN Almera Tino (2.0 year2000airbag)uk, right hand drive) is the module situated and the type of module required i.e N16, P11, etc?
SOURCE: Nissan Almera Tino Right hand side
YEs but if you are going to do some secrifice on your luck of car model from front,
otherwise its impossible,
you can get this from older car dealer or service center,
TNX
SOURCE: Nissan Almera Tino Diesel 2.1 - Temperature control not working
Hi there, very common on these vehicles, you need to remove the heater cotrols and check that the cable hasn't come out, usually the clips that hold the cables in place break causing the heaters to not work properly, Nissan do modified clips now to stop it from happening, it may need a cable too if its too far bent, hope this helps.
SOURCE: Radio says Secure on Nissan Almera Tino (04)
Your radio believes that it has been stolen out of the car since battery power was lost to it (as a result of the car battery going dead). There should be instructions in the user manual on how to reset the radio.
SOURCE: how to find the heater resistor for a nissan
the majority of heater resistors are on the heater box under the passenger ide of the dash, on some very few models it is part of the actual ac control panel
SOURCE: how do I remove the service spanner symbol from a
Try this: With the ignition ON but radio OFF, press in and hold the INFO button and turn volume control until the menu appears. Now choose CONFIRMATION and Enter. Go down and select SERVICE and press Enter. Select RESET and then Enter. Backup to the main menu and now turn ignition off. This should remove it.
341 views
Usually answered in minutes!
×