I recently got a new engine put into my Camry. The engine runs good and sounds great, but the gears do not engage. Also, when in neutral and car is revved to 3k rpm, I put it into drive and it drops significantly before climbing back up. The shift cable is connected and there is the correct amount of transmission fluid. Any ideas?
SOURCE: 1992 4Runner 4wd will not engage
check the wires from the shifter for the transfer case they maybe discounected like mine were now mine works fine
SOURCE: fluid leak, gears won't shift/engage and car begins stalling
Some of these have a small dipstick on the top of the transmission it to check and fill. Do not over fill this it shouldn't take to much to fill. You can try that and see what happens. Transmission fluid should be pink or redish in color if its dark or has a burnt smell then you have a problem. See if this information was help full.
SOURCE: Transmission won't engage in Toyota Tercel
pop off the cap on your clutch reservoir, if it's empty fill it up, leave the cap off, and then pump the clutch 20 times to try to get air out, that should work.
SOURCE: Sister in law driving at 65 mph on turnpike, tried
Did you bleed the air out of the system, also if empty there a leak some where. bleed system and check for leak's, look around for wetness could be a bad slave cylinder, clutch master or the line from clutch master to slave cylinder.
SOURCE: 5 speed 1990 toyota 4wd,my
Sounds like the clutch is not releasing properly. If it grinds when trying to delect reverse this will be the case. It may be a hydrolic fault or the clutch itself. Check to see if the slave cylinder rod is actuating when the pedal is depressed.Check for loss of fluid.
103 views
Usually answered in minutes!
×