Cars & Trucks Logo

Related Topics:

A
Anonymous Posted on Jun 24, 2013

Chevy Tahoe 2002 check engine light on drove it a couple miles and it bogged then died out ? Hook up do tester and its reading code P O 305

1 Answer

Anonymous

Level 2:

An expert who has achieved level 2 by getting 100 points

MVP:

An expert that got 5 achievements.

Governor:

An expert whose answer got voted for 20 times.

New Friend:

An expert that has 1 follower.

  • Expert 134 Answers
  • Posted on Jun 24, 2013
Anonymous
Expert
Level 2:

An expert who has achieved level 2 by getting 100 points

MVP:

An expert that got 5 achievements.

Governor:

An expert whose answer got voted for 20 times.

New Friend:

An expert that has 1 follower.

Joined: Apr 10, 2013
Answers
134
Questions
0
Helped
61205
Points
203

The error code p0305 rises due to misfiring in engine cylinder number 5. The detail description about the problem and it remedy can be found in following link:

http://repairpal.com/OBD-II-Code-P0305

1 Related Answer

Anonymous

  • 1861 Answers
  • Posted on Nov 06, 2008

SOURCE: Check engine and VSC lights on

I talked to you on the live chat, and I think that you may have missed the end of my typing...

What I went on to say is that more often than not, on the 02 4Runners, the Check and VSC lights in tandem look mainly after the emission system, and, since you stated no issues during the road test, I would guess that it is a fuel issue (too full/loose gas cap). But, if you can get the vehicle scanned, I will be very glad to provide you with more and better info if you provide me with the DTC codes. That would require your guy or an autozone hookup to a scan tool. I hope my clarification helps; and the graciouness of a FIxYa rating for this question would be greatly appreciated

Ad

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

0helpful
1answer

2002 Chevy Tahoe. Vehicle felt like it was running out of gas. Pulled into a parking stall. It wasn't idling right then it died. Wouldn't start back up for an hour. When it did finally barely did start I...

Try disconnecting the negative battery cable for a minute or two or reset the ec module. The ecu tries to retune the engine based on codes. If a sensor is bad, then the ecu adjusts other things trying to get a valid reading from the bad sensor (can't happen if broken). At some point, the engine gets so far out of tune that it doesn't run.

If the light comes on again I the next few miles, get the code read again - ask if more than one code is showing. Then check back.
0helpful
1answer

2002 Chevy Tahoe ran out of gas got gas filled it up,started right up drove about 4 miles or less and died out again? Notice check engine light was on?and low engine oil flashed on the dash?So I put a...

you need to do the fallowing :
- make sure that you donr have a n oild leak some where look under the car
- u have a missfire in cylinder number 5 ( it colde be the spark plug or the coil )
if you wana go cheep , start by buying 1 spark plug and change it in number 5 if fix the problem ok if not , get the coil and change it
0helpful
1answer

My 2006 Chevy Tahoe displayed the Reduced Engine power and stability control system turned off. Drove the vehicle home at reduced power never. Temp OK, Battery gage read lower than the normal +14V, Oil...

the post that everybody refuse to read or acknowledge is the first simple instruction
when ever there is a problem , have the fault codes read first
it is free at autozone and other parts shops
then knowing what the problem is you can have it fixed at an accredited service center for less money that fixing what is not faulty costs
1helpful
2answers

2001 chevy monte carlo 3.8 liter v-6: starts fine

is your check engine light on ? if not check the fuel filter it may be plugged. it is also possible that your fuel pressure is low, is it start it then it bogs and dies, for you may have a defective idle air mixture solenoid, this will not call up a code there for no check engine light, hope this helps , let me know good luck
1helpful
1answer

Check engine light is on

I would disconnect the battery for three minutes and reconnect it. That should remove the code. You will have drive the car up to about 75 miles to see if the code does or does not show up again. It may have been reading the amount of air in the system from removal of the injector.
0helpful
1answer

1999 chevy tahoe flashing check engine light and noise

DO NOT DRIVE THE VEHICLE A FLASHING CHECK ENGINE LIGHT COULD IS ASUALY A SERIOUS SAFETY HAZARD TAKE IT TO A SHOP IMMEDIATLY
1helpful
2answers

Check engine light "reduced enging power" message?

hook it up to OBD 2 scan retrieve fault code and go from that point!
Not finding what you are looking for?

169 views

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

john h

Level 3 Expert

29494 Answers

Arnie Burke
Arnie Burke

Level 3 Expert

7339 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...