1992 dodge dakota wont stay running

Dodge Dakota Crank No Start Fix - YouTube

? 8:10
https://www.youtube.com/watch?v=a-rfAd0YLg0
Jun 29, 2014 - Uploaded by AJ Pierce
In this video, I will show you how I fixed my 1992 Dodge Dakotanot starting. ... Engine cranks but won't start - Duration: 18:30. jimthecarguy ...

Inspect Fuses if Engine Cranks But Does Not Start : Dodge ...

repairpal.com > Problems > Dodge > Dakota

Engine Will Not Start Due to Blown Door Lock Fuse on Dodge Dakota ... cap and rotor, wires, plugs, coil, fuel pump assy, coil pickup sensor, crank position sensor and have new ECM on the way, Cranks but won't fire. ... 1990 Dodge Dakota.

Dakota won't Start - Discussion on Topix

www.topix.com > Dodge Dakota

Jan 22, 2009 - have a 1993 dodge dakota sport that wont start. when you turn the key on there is no power to the fuel pump and does not fire. any ideas ... I just bought a1990 Dodge Dakota Sport 4x4 5-Speed, there is only one problem, it only .... I went to move it the other day, it would turn over, but had no spark or gas.

Dodge Dakota Questions - PROBLEM STARTING - CarGurus

www.cargurus.com > Questions > Dodge > Dakota

CarGurus

Best possibility is that you failed to replace or reconnect the crankshaft position sensor after changing the transmission. It is positioned at the rear of the engine at
the top of the transmission bell housing assembly. If this is missing, disconnected, or damaged, the vehicle will crank but never start.

Sounds like you have some injector problems or the fuel pressure regulator. If the check engine light is not on, I would look for something allowing extra fuel into the engine.

If no spark check out the wiring in ignition circuit along with your ecm which fires the plugs.

do you check the battery???
_________
FGTech Galletto 2-Master

What fault codes do you have? to check for fault codes using the check engine light blink method do the following, turn the key to run and then off, then to run and then off, then to run and watch the check engine light, count the blinks, there will be a pause and then more blinks, that is the code(s) So lets say it blinks 2 times and then 5 times, that is code 25. Google the code or codes under the heading: "Dodge OBD1 fault codes"

Check this 1998 Dodge Dakota 2WD 3.9 liter V-6 VIN "X"



Good luck.

it sounds like it might be a crankshaft position sensor (CKP). when it doesnt start try dumping some cold water on the sensor and see if it starts. I had the same problem with my 94 intrepid. Of course there are other things that might cause this problem but it is something to start with.

There is a sensor that located on the right side of trans. that goes into bellhousing up close to the engine, it runs off the flywheel i think its the crank sensor but i'am not sure, i had a simmler problem with one i was working on, replaced that and it ran.

no power to coil from electrical plug in check for a short in the plug on in the wiring